LC72322R Datasheet, PDF (1/13 Pages) Sanyo Semicon Device – Single-Chip Microcontroller with PLL and LCD Driver

Ordering number : EN5378
CMOS LSI
LC72322R, 72323R
Single-Chip Microcontroller with PLL
and LCD Driver
Overview
The LC72322R and LC72323R are single-chip
microcontrollers for use in electronic tuning applications.
These ICs include on chip both LCD drivers and a PLL
circuit that can operate at up to 150 MHz. The LC72322R
and LC72323R feature that these ICs are reversed pin-
assignment versions of LC72322 and LC72323
respectively and have the equal functions and
specifications to theirs respectively.
Functions
• Stack: Eight levels
• Fast programmable divider
• General-purpose counters: HCTR for frequency
measurement and LCTR for frequency or period
measurement
• LCD driver for displays with up to 56 segments
(1/2 duty, 1/2 bias)
• Program memory (ROM): 4095 (8 KB) 16-bit digits:
LC72322R
3071 (6 KB) 16-bit digits:
LC72323R
• Data memory (RAM): 256 4-bit digits
• All instructions are single-word instructions
• Cycle time: 2.67 µs, 13.33 µs, or 40.00 µs (option)
• Unlock FF: 0.55 µs detection, 1.1 µs detection
• Timer FF: 1 ms, 5ms, 25ms, 125ms
• Input ports*: One dedicated key input port and one
high-breakdown voltage port
• Output ports*: Two dedicated key output ports, one
high-breakdown voltage open-drain port
Two CMOS output ports (of which one
can be switched to be used as LCD driver
outputs)
Seven CMOS output ports (mask option
switchable to use as LCD ports)
• I/O ports*: One switchable between input and output
in four-bit units and one switchable
between input and output in bit units
Note: * Each port consists of four bits.
• Program runaway can be detected and a special address
set (Programmable watchdog timer).
• Voltage detection type reset circuit
• One 6-bit A/D converter
• Two 8-bit D/A converters (PWM): LC72322R only
• One external interrupt
• Hold mode for RAM backup
• Sense FF for hot/cold startup determination
• PLL: 4.5 to 5.5 V
• CPU: 3.5 to 5.5 V
• RAM: 1.3 to 5.5 V
• LC72P321R as OTP used
• Package: QIP80DR
Package Dimensions
unit: mm
3223-QFP80DR
[LC72322R, LC72323R]
This LSI can easily use CCB that is SANYO’s original bus format.
• CCB is a trademark of SANYO ELECTRIC CO., LTD.
• CCB is SANYO’s original bus format and all the bus
addresses are controlled by SANYO.
SANYO: QIP80DR
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
93096HA (OT) No. 5378-1/13