16SP33M Datasheet, PDF (1/2 Pages) Sanyo Semicon Device – Large Capacitance, Low ESR Optimum for Audio etc.

4. SPECIFICATIONS FOR EACH SERIES
SP Large Capacitance, Low ESR
Series Optimum for Audio etc.
The characteristics of SP series are large capacitance (about 2 times of
previous value) and low ESR (about half of previous value). It is optimum to
use around MPU of computer equipment. Also, suitable for audio because
OFC is used as the lead wires.
Sleeve color : Purple
Marking : Polarity( ), Rated voltage, Rated Capacitance
(White)
SANYO, OS-CON, Lot.No., Series name
˙Specifications
Upper category temp.(105°C)
Items
Conditions
Characteristics
Category temperature range
-55°C to +105°C
Tolerance on rated capacitance
120Hz
M : ±20%
Tangent of loss angle
120Hz
Less than or equal to the value of Table12
Leakage current
˞2 After 2 minutes
Less than or equal to the value of Table12
ESR
Less than or equal to the value of Table12
Characteristics of impedance
Based the value at
-55°C
Z / Z 20°C
0.75 to 1.25
ratio at high temp. and low temp.
100KHzɼ+20°C
+105°C
Z / Z 20°C
0.75 to 1.25
Endurance
105°C, 1,000 to 2,000h
∆C/C
Within ±20%
˞3
Rated voltage
tanδ 1.5 times or less than an initial standard
applied (25V→20V applied) ˞1 _{Leakage current}
Below an initial standard
Damp heat (Steady state)
60°C, 90 to 95%RH
1,000h,
No-applied voltage
∆C/C
tanδ
Leakage current
Within ±20%
2 times or less than an initial standard
Below an initial standard
Resistance to
soldering heat
Flow method
(260±5°C X 10s)
∆C/C
Within ±5%
tanδ 1.5 times or less than an initial standard
Leakage current Below an initial standard (after voltage processing)
˞1 Please reduce 0.25V per 1°C from over 85°C for 25V products.
˞2 In case of some problems for measured values, measure after applying rated voltage for 2 to 20V products or temperature derating voltage
ɹ for 25V products for 30 minutes at 105°C .
˞3 C', E', F', C, D size : 1,000h. E, F, F0, G size : 2,000h. (2V, 25V, 4SP1000M, 2R5SP1200M : 1,000h)
˙Dimensions
Sleeve
ʢʴʣ
15min.
4min.
L
19min.
Standards of terminal lead position
F
BA
B' ^C
A'
G
Mark ; ideal terminal lead position C;
the middle point of A-A'
Size Code φDʴ0.5max.
C'
6.3
E'
8.0
F'
10.0
C
6.3
D
6.3
E
8.0
F
10.0
F0
10.0
G
12.5
Lmax.
6.0
6.0
6.0
7.8
10.8
11.5
11.5
21.0
23.0
(unit : mm)
F φdʶ0.05 Gmax. Kmax.
2.5±0.5 0.60
0.5
0.5
3.5±0.5 0.60
0.8
0.8
5.0±0.5 0.60
0.8
0.8
2.5±0.5 0.60
0.5
0.5
2.5±0.5 0.60
0.5
0.5
3.5±0.5 0.60
0.8
0.8
5.0±0.5 0.60
0.8
0.8
5.0±0.5 0.80
0.8
0.8
5.0±1.0 0.80
0.8
0.8
˙Size List
RV : Rated voltage (SV) : Surge (room temperature)
µF
RV
(SV)
2
(2.6)
2.5
(3.3)
4
(5.2)
6.3
(8.2)
10
(11.5)
6.8
10
18
22
33
47
56
C'
68
C'
82
C
100
C'
E'
120
C
150
C
E'
D
180
F'
220
E'
F',D
270
D
E
330
F'
390
E
470
F
560
E
680
F
820
F
1000
F
F
1200
F
1500
F0
1800
F0
2200
G
˞For the minimum packing quantity, please refer to page 53.
40
16
(18.4)
C'
C
E'
F',D
E
F
20
(23.0)
C'
C
E'
F',D
E
F
25
(25.0)
C'
C
D
E
F