HCSD-05-01-N Datasheet, PDF (2/2 Pages) Samtec, Inc – IDC SOCKET & TERMINAL CABLE

HCSS–15–S–03.00–01–G
HCSD–10–S–03.00–01–T–G
HCMD, HCMS, HCSD, HCSS SERIES
LEAD
STYLE
–01
= HCSS/HCSD or
(3.05 mm) .120" tail for
HCMS/HCMD
–02
= (5.84 mm) .230" tail
HCMS/HCMD only
PLATING
OPTION
–S
= 10 µ" (0.25 µm) Gold on contact area or tail,
Tin on balance
(Standard on HCSS & HCSD. Leave blank)
–T
= Tin
(Standard on HCMS & HCMD. Leave blank)
NOTCH
POLARIZATION
– N ^{= Notch Polarization}
02
(1.27)
.050
01
(3.81) .150
Required for HCSS and HCSD.
(Not available on HCMS or HCMD,
unless Transfer, then only the
socket is polarized.)
OTHER
OPTIONS
– P “XX”
= Position Polarization
– ST “X”
= Stripped & Tinned
Specify Suffix from table. All
dimensions are ± ¹/16" (1.59 mm). Not
available in 28 positions and higher.
–S “XX”
= Daisy Chain Single
(50.80)
2.00
min.
“XX” ± ¹/₈" (3.18)
Single Row
Connectors
–R
= Reversed
02
01
04
03
02
01
04
03
Single
Double
Specify “XX” as position. For Double
the same position will be polarized
on both ends. (Not available on
HCM, unless Transfer, then only the
socket is polarized)
–ST8
–ST4
–ST2
–ST3
1_{/8" (3.18)}
1_{/4" (6.35)}
1_{/2" (12.70)}
3_{/8" (9.53)}
3
– B “XX”
= Breakout
Specify “XX” as number of
conductors to be broken out.
(101.60)
4.00 minimum
Outer Most
(End of
Assembly)
When mating double row connector
with two single row connectors, the
outer most single will be connected
to Conductor #1 and the inside single
to Conductor #2.
6
– D “XX”
= Daisy Chain, Double
(50.80)
2.00
min.
“XX” ± ¹/₈" (3.18)
Double Row
Strips
1
–G
= Gray Cable
Standard cable is color coded. Specify
–G for Gray cable with one red edge.
“XX”
(127.00)
Breakout starts with Number 1
lead indicated by brown wire or
red stripe. Shown on top side.
5.00 max.
(50.80)
2.00 min.
4
– RW
= Reversed Wiring
#1 wire opposite position #1
2
5
(101.60)
4.00 minimum
Outer Most
(End of
Assembly)
6
–W “XX”
= Wiring Reversed
Daisy Chain, Single
Same as –S “XX” except outer strip
connected to conductor #2 and inside
strip connected to conductor #1.
6
WWW.SAMTEC.COM
Due to technical progress, all designs, specifications and components are subject to change without notice.
7
–M
= Middle Reversed
Requires –SXX, –WXX or –DXX
7
–O
= Outside Reversed
Requires –SXX, –WXX or –DXX
7