ASP-142781-01 Datasheet, PDF (1/3 Pages) Samtec, Inc – 1. .608 STACKER HEIGHT NOT AVAILABLE AS STANDARD.

REVISION C
DO NOT
SCALE FROM
THIS PRINT
NOTES:
1. .608 STACKER HEIGHT NOT AVAILABLE AS STANDARD.
2. C REPRESENTS A CRITICAL DIMENSION.
3. BURR ALLOWANCE: .0015[0.038] MAX.
4. MINIMUM PUSHOUT FORCE: SIGNAL: .5 LB, GROUND: 1 LB.
5. MAX VARIANCE OF .002[0.05].
6. DIMENSION APPLIES TO CONTACTS & GROUND PLANES.
7. GROUND PLANE PRESS HEIGHT MUST BE .003[0.08] LESS THAN THE MAX HEIGHT
OR .001[0.03] GREATER THAN THE MINIMUM HEIGHT OF THE TERMINAL.
8. PARTS TO BE PACKAGED IN TAPE & REEL.
9. FOR QUANTITIES UP TO 49 PIECES, NO LEADER, TRAILER, OR EIA-481-D REEL WILL BE SUPPLIED.
FOR QUANTITIES OF 50-100 PIECES, NO LEADER, TRAILER WILL BE SUPPLIED.
10. PARTS TO BE TRAY PACKAGED ONLY FOR VISION PROCESS.
FOR ALL PREVIOUS MANUFACTURING STEPS PARTS ARE TO BE PACKAGED IN LAYERS
.090 2.29
REF
C1 _{.835 21.21}
(((26 POS/26) x .840[21.34]) - .005[0.13])
C2 _{.625 15.88}
25 EQ SPACES @ .0250[.635]
01
.286 7.26
REF
.295±.020 7.48±0.51
1
5
.009 0.23 REF
.835 21.21 REF
"A"
02
.216 5.49
REF
.250 6.35
REF
.035±.020 0.89±0.51
REF: QMS-XXX-XX.XX-XX-D-XX-XXX-XX
2
.035 0.89
REF
"A"
.735 18.67
.105 2.67 REF
.040 1.02 REF
(TYP)
POLARIZATION
NOTCHES
UNLESS OTHERWISE SPECIFIED,
DIMENSIONS ARE IN INCHES.
TOLERANCES ARE:
DECIMALS
ANGLES
.XX: .01[.3]
2
.XXX: .005[.13]
.XXXX: .0020[.051]
PROPRIETARY NOTE
THIS DOCUMENT CONTAINS INFORMATION
CONFIDENTIAL AND PROPRIETARY TO
SAMTEC, INC. AND SHALL NOT BE REPRODUCED
OR TRANSFERRED TO OTHER DOCUMENTS OR
DISCLOSED TO OTHERS OR USED FOR ANY
PURPOSE OTHER THAN THAT WHICH IT WAS
OBTAINED WITHOUT THE EXPRESSED WRITTEN
CONSENT OF SAMTEC, INC.
DO NOT SCALE DRAWING
SHEET SCALE: 1:0.4
PLATING:
CONTACT AREA: .000030 GOLD OVER .000050 NICKEL
REMAINDER: .000200 REF TIN OVER .000050 NICKEL
520 PARK EAST BLVD, NEW ALBANY, IN 47150
PHONE: [phone] FAX: [phone]
e-Mail: [e-mail]
code: 55322
DESCRIPTION:
ELEVATED QMS ASSM (22MM STACK)
DWG. NO. _{ASP-142781-01}
c:\enterprisevault\DWG\MISC\MKTG\ASP-142781-01-MKT.SLDDRW
BY: C. RYAN
10/17/2008 SHEET 1 OF 3