KMM372F213CS Datasheet, PDF (6/20 Pages) Samsung semiconductor – 2M x 72 DRAM DIMM with ECC using 2Mx8, 2K Refresh, 3.3V

DRAM MODULE
KMM372F213CK/CS
NOTES
1. An initial pause of 200us is required after power-up followed
by any 8 RAS-only or CAS-before-RAS refresh cycles before
proper device operation is achieved.
2. ^{Input voltage levels are Vih/Vil. VIH(min) and VIL(max) are}
reference levels for measuring timing of input signals. Transi-
tion times are measured between VIH(min) and VIL(max) and
are assumed to be 5ns for all inputs.
3. Measured with a load equivalent to 1 TTL loads and 100pF.
Voh=2.0V and Vol=0.8V.
If tCWD≥tCWD(min), tRWD≥tRWD(min) and tAWD≥tAWD (min),
then the cycle is a read-write cycle and the data output will
contain data read from the selected address. If neither of the
above conditions are satisfied, the condition of the data out
is indeterminated.
8. Either tRCH or tRRH must be satisfied for a read cycle.
9. These parameters are referenced to the CAS leading edge in
early write cycles and to the W leading edge in read-write
cycles.
4. Operation within the tRCD(max) limit insures that tRAC(max)
can be met. tRCD(max) is specified as a reference point only.
If tRCD is greater than the specified tRCD(max) limit, then
access time is controlled exclusively by tCAC.
10. Operation within the tRAD(max) limit insures that tRAC(max)
can be met. tRAD(max) is specified as reference point only. If
tRAD is greater than the specified tRAD(max) limit, then
access time is controlled by tAA.
5. Assumes that tRCD≥tRCD(max).
6. This parameter defines the time at which the output achieves
the open circuit condition and is not referenced to VOH or
VOL.
7. tWCS, tRWD, tCWD and tAWD are non restrictive operating
parameter. They are included in the data sheet as electrical
characteristics only. If tWCS≥tWCS(min) the cycle is an early
write cycle and the data out pin will remain high impedance
for the duration of the cycle.
11. tCEZ(max), tREZ(max), tWEZ(max) and tOEZ(max) define the
time at which the output achieves the open circuit condition
and are not referenced to output voltage level.
12. If RAS goes to high before CAS high going, the open circuit
condition of the output is achieved by CAS high going. If CAS
goes to high before RAS high going , the open circuit condi-
tion of the output is achieved by RAS high going.
13. tASC≥tCP min
14. The timing skew from the DRAM to the DIMM resulted from
the addition of buffers.