SA9102C Datasheet, PDF (6/12 Pages) Sames – SINGLE PHASE UNIDIRECTIONAL POWER/ENERGY METERING IC PULSE OUTPUT

SA9102C
3. Electrostatic Discharge (ESD) Protection
The SA9102C integrated circuit's inputs/outputs are protected against ESD according
to Mil-Std 883C, method 3015.
4. Power Consumption
The power consumption rating of the SA9102C integrated circuit is less than 50mW.
TYPICAL APPLICATIONS
In the Application Circuits (Figures 1 and 2) the components required for power metering
applications, are shown.
In Figure 1 a shunt resistor is used for current sensing. In this application, the circuit
requires a +2.5V, 0V, -2.5V DC supply.
In the case of Figure 2, when using a current transformer for current sensing, a +5V, 0V
DC supply is sufficient.
The most important external components for the SA9102C integrated circuit are:
C and C are the outer loop capacitors for the two integrated oversampling A/D
1
2
converters. The value of these capacitors is 560pF.
The actual values determine the signal to noise and stability performance. The tolerances
should be within ±10%.
C₃ and C₄ are the inner loop capacitors of the A/D converters. The optimum value is
3.3nF. The actual values are uncritical. Values smaller than 0.5nF and larger than 5nF
should be avoided.
R , R and RSH are the resistors defining the current level into the current sense input.
21
The values should be selected for an input current of 16µA into the SA9102C at maximum
line current.
Values for RSH of less than 200µΩ should be avoided.
R₁ = R₂ = (I_L/16µA) * R_SH/2
Where I
= Line current
L
RSH = Shunt resistor/termination resistor
R , R and R set the current for the voltage sense input. The values should be selected
36
4
so that the input current into the voltage sense input (virtual ground) is set to 14µA.
R
7
defines all on-chip bias and reference currents.
With
R
7
=
24kΩ,
optimum
conditions
are set. R₇ may be varied within ±10% for calibration purposes. Any change to R₇ will
affect the output quadratically (i.e.: R = +5%, f = +10%).
7
p
6/12
sames