RS6-R30 Datasheet, PDF (1/3 Pages) RSG Electronic Components GmbH – 3.0 Watt regulated single output

RS6-R30
3.0 Watt regulated
single output
■ _{12 Pin SIP12 package}
■ _{1000 VDC isolation up to 3000 VDC isolation}
■ _{Continuous short circuit protection}
■ _{Efficiency up to 71%}
■ _{-25°C~71°C operation temperature range}
SIL 12 package, pic. similar
OUTPUT SPECIFICATIONS
Voltage accuracy
± 2%
Line regulation
± 0.5%
Load regulation (From 0% to 100% Load)
± 0.5%
(3.3 V output model)
± 1.5%
Ripple & Noise (20 MHz bandwith) (1)
75 mV pk-pk
Short circuit protection Indefinite (automatic recovery)
Temperature coefficient
± 0.02%/°C
Capacitor load (2)
See table
ABSOLUTE MAXIMUM RATINGS (4)
These are stress ratings. Exposure of devices to any of these
conditions may adversely affect long-term reliability.
Input voltage (100 mS)
5 modes
0 ~ 7 VDC
12 modes
0 ~ 15 VDC
24 modes
0 ~ 28 VDC
Lead soldering temperature 260°C
(1.5 mm from case 10 sec.)
INPUT SPECIFICATIONS
Voltage range
Max. input current
No-load input current
Input filter
Input reflected ripple current (3)
± 10%
See table
See table
Capacitors
20 mA pk-pk
All specifications typical at Ta = 25°C, nominal input voltage and full load
unless otherwise specified.
The information and specifications contained in this data sheet are believed
to be correct at time of publication. However, we accept no responsibility
for consequences arising from printing errors or inaccuracies.
Subject to change without notice.
GENERAL SPECIFICATIONS
Efficiency
See table
I/O isolation voltage (3 sec.)
Input / output
1000 ~ 3000 VDC
I/O isolation capacitance
60 pF typ.
I/O isolation resistance
1000 M Ohm
Switching frequency
50 kHz typ.
Humidity
95% rel. H
Reliability calculated MTBF (MIL-HDBK-217F) > 1.12 Mhrs.
Safety standard (designed to meet)
IEC 60950-1
NOTE
1) Ripple / Noise measured with 20 MHz bandwith.
2) Tested by minimal Vin and constant resistive load.
3) Measured input reflected ripple current with a simulated
source inductance of 12uH.
4) Exceeding the absolute ratings of the unit could cause
damage. It is not allowed for continuous operating.
5) Operation under no-load conditions will not damage
these devices. However they may not meet all listed
specifications.
PHYSICAL SPECIFICATIONS
Case material
Non-conductive black plastic
(UL94V-0 rated)
Pin material
0.5 mm Alloy42 solder-coated
Potting material
Epoxy (UL94V-0 rated)
Weight
7.2 g
Dimensions
1.26“ x 0.32“ x 0.57“
The models listed are just for standard type. If you need a
special specification product, please contact our service.
Phone: [phone], mail to: [e-mail]
or use the forms on www.rsg-electronic.de („Kontakt“).
ENVIRONMENT SPECIFICATIONS
Operating temperature
-25°C~ 71°C
(See derating curve)
Maximum case temperature
100°C
Storage temperature
-40°C~125°C
Cooling
Nature convection
Page: 1/3
Last update: 18.02.09