PU150 Datasheet, PDF (1/3 Pages) Tumbler Technologies + TRUMPower – 150 WATT SWITCHING POWER SUPPLIES

RSG■
ELECTRONIC COMPONENTS
RSG Electronic Components GmbH ^■ Sprendlinger Landstr. 115 ^■ D-63069 Offenbach/Germany
Tel. [phone] ^■ Fax [phone] ^■ [e-mail] ^■ www.rsg-electronic.de
Änderungen vorbehalten / subject to change without notice
150 WATT SWITCHING POWER SUPPLIES
DESCRIPTION
The PU150 series comprises single and multiple output models
for 150 watts of continuous output power. Auto-ranging input
allows them to operate from any line voltage throughout the
world without a selector strap. All auxiliary outputs are with
magnetic amplifier to keep regulation. The units are
constructed on a printed circuit board with a U-bracket for
mechanical support and heat sinking, in 1U height.
PU150 SERIES
(LVD)
F E AT U R E S
h Auto-ranging input
h Overvoltage protection
h Short-circuit protection with auto-recovery
h Power Fail Detect€ PFD signal on models
With 5V output
h 100č burn-in at full rated load
INPUT SPECIFICATIONS
Input voltagej
Input frequencyj
Input currentj
Leakage currentj
8 5 t o 1 3 2 VA C , o r 1 7 0 t o
2 6 4 VA C € a u t o - r a n g i n g 
47 to 63 Hz
3 . 4 A € r m s  f o r 11 5 VA C
2 . 0 A € r m s  f o r 2 3 0 VA C
0 . 4 m A m a x . @ 11 5 VA C , 6 0 H z
0 . 8 m A m a x . @ 2 3 0 VA C , 5 0 H z
OUTPUT SPECIFICATIONS
Output voltage/currentj
Total output powerj
See rating chart
150 watts maximum at 30 CFM
forced air cooling or 110 watts
maximum at convection cooling
Ripple and noisej
1čpeak to peak maximum
Overvoltage protectionj
Overcurrent protectionj
Provided on output #1 only; set
at 112-136čof its nominal
output voltage
All outputs protected to short
circuit conditions
Temperature coefficientj All outputs ±0.04č /Ċ
maximum
Transient responsej
Maximum excursion of 4čor
better on all models, recovering
to 1čof final value within 500us
after a 25čstep load change
ENVIRONMENTAL SPECIFICATIONS
Operating temperaturej
Storage temperaturej
Relative humidityj
Deratingj
0Ċ to +70Ċ
-40Ċ to +85Ċ
5č to 95% non-condensing
Derate from 100č at +50Ċ
Linearly to 50čat +70Ċ
Safety Standard Approvalsj
UL 60950-1
File No. E137410
CSA C22.2 No. 60950-1
File No. LR93632
TÜV EN60950-1
Certificate No. R9954992
GENERAL SPECIFICATIONS
Switching frequencyj 120KHz ±15%
Efficiencyj
Hold-up timej
Line regulationj
70čtypical on all models
15 msec minimum at 115VAC
±0.5čmaximum at full load
Inrush currentj
Withstand voltagej
20 amps @ 115VAC, or 40 amps @
230VAC, at 25Ċ cold start
3000VAC from input to output
1500VAC from input to ground
500VAC from output to ground
MTBFj
300,000 hours minimum at full load at
25Ċambient, calculated per
MIL-HDBK-217F
EMC performance (EN55024)
EN55022:
Class B conducted, Class B radiated
FCC:
VCCI:
Class B conducted, Class B radiated
Class B conducted, Class B radiated
EN61000-3-2: Harmonic distortion, Class A
EN61000-3-3:
EN61000-4-2:
Line flicker
ESD, ± 8KV air and ± 4KV contact
E N 6 1 0 0 0 - 4 - 3 : Radiated immunity, 3V/m
EN61000-4-4: Fast transient/burst, ± 1KV
EN61000-4-5: Surge, ± 1KV diff., ± 2KV com.
E N 6 1 0 0 0 - 4 - 6 : Conducted immunity, 3Vrms
E N 6 1 0 0 0 - 4 - 8 : Magnetic field immunity, 1A/m
EN61000-4-11:
Voltage dips, 30 č reduction for 500ms and
>95čreduction for 10ms
1-11