PSP-1500 Datasheet, PDF (1/2 Pages) Total Power International – 1500W Single Output with PFC Function

RSG RSG Electronic Components GmbH ■ Sprendlinger Landstr. 115 ■ D-63069 Offenbach/Germany
■ _{Tel. [phone]} ■ _{Fax [phone]} ■ _[e-mail] ■ _{www.rsg-electronic.de}
ELECTRONIC COMPONENTS Änderungen vorbehalten / subject to change without notice
1500W Single Output with PFC Function
PSP-1500 series
Features :
AC input active surge current limiting
Built-in active PFC function
Protections:Short circuit/Over load/Over voltage/Over temperature
Built-in constant current limiting circuit
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
SPECIFICATION
MODEL
PSP-1500-5 PSP-1500-12 PSP-1500-13.5 PSP-1500-15 PSP-1500-24 PSP-1500-27 PSP-1500-48
DC VOLTAGE
RATED CURRENT
CURRENT RANGE
5V
217.5A
0 ~ 217.5A
12V
112.5A
0 ~ 112.5A
13.5V
100.5A
0 ~ 100.5A
15V
90A
0 ~ 90A
24V
56.4A
0 ~ 56.4A
27V
50.4A
0 ~ 50.4A
48V
28.5A
0 ~ 28.5A
RATED POWER
1087.5W
1350W
1356.75W
1350W
1353.6W
1360.8W
1368W
OUTPUT
INPUT
PEAK LOAD
Note.4 ^1200W
1500W
RIPPLE & NOISE (max.) Note.2 ^100mVp-p
150mVp-p
VOLTAGE ADJ. RANGE
4.75 ~ 5.5V
10 ~ 13.2V
VOLTAGE TOLERANCE Note.3 ^6.0%
LINE REGULATION
0.5%
3.0%
0.3%
LOAD REGULATION
2.0%
0.5%
SETUP, RISE TIME
1500ms, 50ms/230VAC at full load
HOLD TIME (Typ.)
24ms/230VAC at full load
VOLTAGE RANGE
176 ~ 264VAC 248 ~ 370VDC
FREQUENCY RANGE
47 ~ 63Hz
POWER FACTOR (Typ.)
0.96/230VAC at full load
EFFICIENCY (Typ.)
77%
84%
AC CURRENT (Typ.)
8.4A/230VAC
INRUSH CURRENT (Typ.) 80A/230VAC
1500W
150mVp-p
12 ~ 15V
2.0%
0.3%
0.5%
84%
1500W
150mVp-p
13.5 ~ 18V
2.0%
0.3%
0.5%
84%
1500W
150mVp-p
20 ~ 26.4V
1.0%
0.2%
0.5%
85%
1500W
150mVp-p
24 ~ 30V
1.0%
0.2%
0.5%
85%
1500W
200mVp-p
41 ~ 56V
1.0%
0.2%
0.5%
86%
LEAKAGE CURRENT
<3.5mA / 240VAC
OVER LOAD
PROTECTION ^{OVER VOLTAGE}
115 ~ 140% rated output power
Protection type : Constant current limiting, recovers automatically after fault condition is removed
5.75 ~ 6.75V 13.8 ~ 16.2V 15.5 ~ 18.2V 18 ~ 21V
27.6 ~ 32.4V 31 ~ 36.5V
Protection type : Shut down o/p voltage, re-power on to recover
57.6 ~ 67.2V
OVER TEMPERATURE
FUNCTION REMOTE CONTROL
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT ^{STORAGE TEMP., HUMIDITY}
TEMP. COEFFICIENT
VIBRATION
SAFETY STANDARDS
95 (TSW1) Detect on the heatsink of PFC MOSFET 90 (TSW2) Detect the winding of output choke
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
RC+/RC-: 0 ~ 0.8V=power on ; 4 ~ 10V=power off sink current <30mA
-10 ~ +60 (Refer to output load derating curve)
20 ~ 90% RH non-condensing
-20 ~ +85 , 10 ~ 95% RH
0.03%/ (0 ~ 50
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
UL60950-1, TUV EN60950-1 Approved
WITHSTAND VOLTAGE
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC
EMC
EMI CONDUCTION & RADIATION ^{Compliance to EN55022 (CISPR22) Class B}
(Note 5) _{HARMONIC CURRENT}
Compliance to EN61000-3-2,-3
OTHERS
EMS IMMUNITY
MTBF
DIMENSION
PACKING
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A
43.4K hrs min. MIL-HDBK-217F (25 )
278*129*190.5mm (L*W*H)
7.4Kg; 2pcs/15.5Kg/1.28CUFT
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. 10% Duty cycle maximum within every 30 seconds(max.). Average output power should not exceed the rated power.
5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
File Name:PSP-1500-SPEC 2006-04-13