SMC700 Datasheet, PDF (2/2 Pages) Roithner LaserTechnik GmbH – Visible LED

Soldering Conditions
• DO NOT apply any stress to the lead particularly when heat.
• After soldering the LEDs should be protected from mechanical shock or vibration until the LEDs
return to room temperature.
• When it is necessary to clamp the LEDs to prevent soldering failure, it is important to minimize the
mechanical stress on the LEDs.
Temperature Profile
PCB Footprint Layout
(Unit: mm)
Static Electricity
• LEDs are very sensitive to Static Electricity and surge voltage. It is recommended to always wear
a wrist band or an anti-electrostatic glove when handling the LEDs.
• All devices, equipment and machinery must be grounded properly. It is recommended that
precautions should be taken against surge voltage to the equipment that mounts the LEDs.
14.11.2013
SMC700
2 of 2