BU9889GUL-W Datasheet, PDF (9/18 Pages) Rohm – WL-CSP EEPROM family I2C BUS

BU9889GUL-W
○Notes on page write cycle
Maximum page number is 16 bytes for this IC.
Any bytes below these can be written.
The page write cycle write time is 5ms at maximum for 16byte bulk write.
It does not stand 5ms at maximum × 16byte = 80ms(Max.).
○Internal address increment
Page write mode
Technical Note
WA7 ----- WA4 WA3
0 ----- 0
0
0 ----- 0
0
0 ----- 0
0
WA2
0
0
0
WA1
0
0
1
WA0
0
1
0
Increment
0Eh ^{0 ----- 0}
0 ----- 0
0 ----- 0
1
1
1
0
1
1
1
1
0
0
0
0
Significant bit is fixed.
No digit up
For example, when it is started from address 0Eh,
therefore, increment is made as below,
0Eh→0Fh→00h→01h･･･, which please note.
* 0Eh･･･16 in hexadecimal, therefore, 00001110 becomes a binary number.
○Write protect (WP) terminal
・Write protect (WP) function
When WP terminal is set Vcc (H level), data rewrite of all address is prohibited. When it is set GND (L level), data rewrite
of all address is enabled. Be sure to connect this terminal to Vcc or GND, or control it to H level or L level. Do not use it open.
At extremely low voltage at power ON/OFF, by setting the WP terminal 'H', mistake write can be prevented.
During tWR, set the WP terminal always to 'L'. If it is set 'H', write is forcibly terminated.
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
9/17
2010.01 - Rev.A