|
BU97941FV Datasheet, PDF (8/25 Pages) Rohm – Multifunction LCD Segment Driver | |||
|
◁ |
BU97941FV MAX 104 segments (SEG26ÃCOM4)
Datasheet
âLCD Driver Bias / Duty Circuit
Voltage is generated for LCD drive.
Buffer amplifier is integrated low power consumption is possible.
ï¼Line, frame inversion can be set via MODESET command.
ï¼1/4, 1/3, static duty can be set via DISCTL command.
For each liquid crystal drive waveform, see âLiquid crystal Drive Waveformâ.
âReset Initial State
The Reset Initial State after executing Software Reset is as follows:
ã» Display is turned OFF.
ã» Each command register enters Reset state.
ã» DDRAM address is initialized.
(DDRAM data is not initialized. Therefore, it is recommended to write initial values to all DDRAM before Display on.ï¼
âCommand / Function Table
Function Description Table
NO Command
1 Mode Set (MODESET)
2 Display control (DISCTL)
3 Address set (ADSET)
4 LED control (LEDCTL)
5 RAM WRITE (RAMWR)
6 All Pixel ON (APON)
7 All Pixel OFF (APOFF)
8 All Pixel On/Off mode off (NORON)
9 Software Reset (SWRST)
Function
Liquid crystal Drive setting
LCD setting1
LCD setting2
LED board ON/OFF setting
RAM Write Start setting
All display ON
All display OFF
Normal display APON/APOFF setting releaseï¼
Software reset
www.rohm.com
© 2012 ROHM Co., Ltd. All rights reserved.
TSZ22111ï½¥15ï½¥001
8/22
TSZ02201-0A0A2D300080-1-2
1.Jun.2012 Rev.001
|
▷ |