BU95303 Datasheet, PDF (7/15 Pages) Rohm – 6bit RSDS Source Driver

BU95303
Technical Note
●Pin Descriptions
Pin Name
D_00P/N ~ D_02P/N
D_10P/N ~ D_12P/N
D_20P/N ~ D_22P/N
CLK_P/N
Y1 ~ Y432
R/L
SEL0
SEL1
LPC0
LPC1
SFTR
SFTL
STB
INV
V0 ~ V13
POL
IREP1,2
OREP1,2
AV_DD
AV_SS
DV_DD
DV_SS
In/Out
In
In
Active
Differential
Differential
Descriptions
RSDS^TM input terminals of display data
The 3-bit differential input pairs generate the internal 6-bit data through the
comparison between D_XXP and D_XXN.
The RSDS^TM clock input pair generate the internal shift clock through the
comparison between CLK_P and CLK_N.
Out
-
Driver outputs for D/A converted 64 gray scale analog voltage.
The shift direction of internal shift register is controlled by this pin as shown below.
In
-
R/L=H : Right shift SFTR→Y1→Y432→SFTL
R/L=L : Left shift SFTL→Y432→Y1→SFTR
The output channel number is controlled by this pin as shown below.
SEL1
SEL0
Number of effective
output terminal
Invalid output terminal
In
-
H
H
H
L
384
Y193 ~ Y240 become Hi-Z
414
Y208 ~ Y225 become Hi-Z
L
H
420
Y211 ~ Y222 become Hi-Z
L
L
432(default)
-
This pin is pulled down to the DV_SS inside the IC.
Low power control pin
LPC1 LPC0
power condition
H
H
Strong power
In
H
H
L
Normal power
L
H
Ultra-low power
L
L
Low power(default).
This pin is pulled down to the DV_SS inside the IC.
In/Out
H
SFTR=H: Right shift start pulse input terminal in cascade connection.
SFTR=L: Carry output terminal in cascade connection.
In/Out
H
SFTL=H: Carry output terminal in cascade connection.
SFTL=L: Left shift start pulse input terminal in cascade connection.
In
The data in the data register are transferred to the data latch at the rising edge of STB,
then the gray scale voltages are output from the buffer at the falling edge of STB.
Terminal to specify inverting or non-inverting of display data
In
H
INV:H : Input data are inverted in the IC.
INV:L : Input data are not inverted.
In
-
Input for the γ-correction reference voltage
The following external reference voltages are input.
At the rising edge of STB, the state of POL are transferred to the driver.
POL=H : The reference voltage for odd number outputs are V0 to V6 and those
In
-
for even number outputs are V7 to V13.
POL=L : The reference voltage for odd number outputs are V7 to V13 and those
for even number outputs are V0 to V6
In
-
Repair amplifier input
Out
-
Repair amplifier output
In
-
Power supply for driver block
In
-
Ground for AV_DD
In
-
Power supply for digital block
In
-
Ground for DV_DD
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
7/14
2010.10 - Rev.A