SMLP36RGB2W3 Datasheet, PDF (6/7 Pages) Rohm – SMLP36 series

SMLP36 series
Data Sheet
5.EROSION GAS
Utilization in erosion gas atmosphere may degenerate the plating surface which might cause deterioration of
solder strength, optical characteristics, or functions.
Please take precautions against occurrence of gas from the surrounding parts on the occasion of custody,
and also after mounted on circuit board.
7.STORAGE
At reflow soldering, the reliability of this product is often influenced by moisture absorption;
so that we apply the package with moisture proof for better condition for use. Please also note that,
7-1) Package : Not to be opened before using.
7-2) After unpackaging : LEDs to be kept in our moisture proof package with some desiccant (SILICA GEL).
LEDs to be baked in case the SILICAGEL indicator changed its color from either blue to clear or green to pink.
7-3) Please use LEDs within 168 hours after the package is opened. (Condition at 30ºC, max.70%Rh.)
In case they are not used within 168 hours, please put them back into the package.
7-4) BAKING (=Moisture Removal)
Please conduct baking under “reel condition” at 60ºC, 12～24 hours (max.20%Rh) after unpackaging.
Please be careful not to give any stress to the reel & the embossed tape while baking, as they are susceptible
to be deformed during the baking.
7.LIFE TIME
Blue led die used in this product will cause reduction of luminous intensity due to epoxy resin discoloration
depending on the using conditions and environmental.
Please inquire our sales contact if long life time is required on your application.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
6/6
2013.09 - Rev.F