TCFG_D_12 Datasheet, PDF (5/7 Pages) Rohm – Chip tantalum capacitors with (Fail-safe open structure type)

TCFG Series D Case
Data Sheet
Item
Dimensions
Performance
Be based on "External dimensions"
Resistance to solvents The indication should be clear.
Solderability
3/4 or more surface area of the solder coated
terminal dipped in the soldering bath should be
covered with the new solder.
Test conditions
(based on JIS C5101-1 and JIS C5101-3)
Measure using a caliper of JIS B 7505
Class 2 or higher grade.
As per 4.32 JIS C 5101-1
As per 4.18 JIS C 5101-3
Dip in the isopropyl alcohol for 30±5s,
at room temperature.
As per 4.15.2 JIS C 5101-1
As per 4.7 JIS C 5101-3
Dip speed = 25±2.5mm/s
Pre-treatment (accelerated aging) : Leave the
sample on the boiling distilled water for 1h.
Solder temp. : 245±5°C
Duration : 3±0.5s
Solder : M705
Flux : Rosin 25%, IPA 75%
Vibration Capacitance Measure value should not fluctuate during the
measurement.
Appearance There should be no significant abnormality.
As per 4.17 JIS C 5101-1
Frequency : 10 to 55 to 10Hz/min.
Amplitude : 1.5mm
Time : 2h each in X and Y directions
Mounting : The terminal is soldered on a print
circuit board.
Table 1 standard list, TCFG series D Case
Part No.
Rated
Voltage
@85°C
(V)
Derated
Voltage
@125°C
(V)
Surge
Voltage
@85°C
(V)
Leakage
Capacitance
120Hz
(µF)
Tolerance
(%)
current
25°C
1WV.60s
(mA)
DF120Hz
(%)
Impedance
100kHz
−55°C 25°C 125°C _(Ω)
85˚C
Case
code
∗ TCFG D 0G 337 MCR 4
2.5
5
330 ±20 13.2 32 14 20 0.7
D
TCFG D 0J 227 MCR 6.3
4
8
220 ±20 13.8 30 12 16 0.7
D
TCFG D 1A 157 MCR 10
6.3
13
150 ±20 15.0 14 10 12 0.7
D
TCFG D 1C 107 MCR 16
10
20
100
±20
16
14 10 12 0.7
D
TCFG D 1E 476 MCR 25
16
32
47
±20 11.8 14 10 12 0.7
D
TCFG D 1V 226 MCR 35
22
44
22
±20
7.7
14 10 12 0.8
D
∗ = Under development
www.rohm.com
5/6
○^c 2012 ROHM Co., Ltd. All rights reserved.
2012.03 - Rev.I