SMF30V Datasheet, PDF (5/10 Pages) Rohm – Transient Voltage Suppressor

SMF30V
　 　 　 　 　 　 　 　 　 　 　 　 　 　　　　　　　　　 _{Data sheet}
●Appended figure
Procedure to obtain ESD Clampimg Voltage
IEC61000-4-2 Spec
IEC61000-4-2 Waveform
C_S:150pF　R_d:330Ω
simplified diagram in ESD machine
1. Set up ESD Tester at IEC61000-4-2 condition.
(IEC61000-4-2 ：C=150pF, R=330Ω)
2. Mount a sample on the high frequency test board
with the SMA connector.
3. Connect the SMA connector to the oscilloscope
by 50Ωcable.
Then, add the 10X-attenuator between test board
and the cable to protect the oscilloscope.
4. Discharge ESD in contact discharge mode at any voltage.
(normally 8kV Max.)
　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　 　　 　 　 　 　 　 　 　 　 　 　
www.rohm.com
© 2017 ROHMCo., Ltd.All rights reserved.
5/6
　　　
2017/04/06_Rev.002