TCO_A Datasheet, PDF (4/6 Pages) Rohm – Chip tantalum capacitors

TCO Series A Case
Item
Performance
Loading at
Appearance There should be nonsignificant
High temperature
abnormality.
L.C
Less than 400% of initial limit
∆C / C
Within +− 20% of initial value
Df
(tan δ)
300% of initial limit less than
Terminal strength Capacitance The measured value should be stable.
Appearance There should nonsignificant abnormality.
Adhesiveness
The terminal should not come off.
Data Sheet
Test conditions
(based on JIS C 5101−1 and JIS C 5101−3)
After applying the rated voltage for 1000⁺⁷² h
without discontinuation via the serial resistance
of 3Ω or less at a temperature of 85 ^+−2 C, leave
the sample at room temperature / humidity for
over 24h and measure the value.
A force is applied to the terminal until it bends
to 1mm and by a prescribed tool maintain the
condition for5s.(See the figure below)
20
50
(Unit : mm)
F (Apply force)
R230
thickness=1.6mm
1mm
45 45
Apply force of 5N in the two directions shown
in the figure below for 10 _−+ 1s after mounting the
terminal on a circuit board.
product
Apply force
a circuit board
Dimensions
Refer to "External dimensions"
Measure using a caliper of JISB 7507 Class 2
or higher grade.
Resistance to solvents
Solderability
The indication should be clear
3/4 or more surface area of the solder coated
terminal dipped in the soldering bath should
be covered with the new solder.
Vibration
Capacitance Measure value should not fluctuate during the
measurement.
Appearance _{There should no significant abnormality.}
Dip in the isopropyl alcohol for 30_−+ 5s, at room
temperature.
Dip speed=25^+− 2.5mm / s
Pre−treatment(accelerated aging): Leave
the sample on the boiling distilled water for 1 h.
Solder temp..: 245^+− 5 C
Duration : 3^+− 0.5s
Solder
: M705
Flux
: Rosin25%
IPA75%
Frequency : 10 to 55 to 10Hz/min.
Amplitude : 1.5mm
Time : 2h each in X and Y directions
Mounting : The terminal is soldered on a print
circuit board.
www.rohm.com
○^c 2009 ROHM Co., Ltd. All rights reserved.
4/5
2009.01 - Rev.E