TCFG_A_10 Datasheet, PDF (4/8 Pages) Rohm – Chip tantalum capacitors (Fail-safe open structure type)

TCFG Series A Case
Data Sheet
Item
Performance
Temperature Temp.
Stability
ΔC / C
−55°C
Within 0/−12%of initial value
tanδ
L.C
Temp.
Shall be satisfied the voltage on "Standard list"
−
+85°C
ΔC / C
Within +10/0%of initial value
tanδ
L.C
Temp.
Shall be satisfied the voltage on "Standard list"
Less than 1000% of initial limit
+125°C
ΔC / C
Within +15/0%of initial value
Surge
Voltage
tanδ
Shall be satisfied the voltage on "Standard list"
L.C
Less than 1250% of initial limit
Appearance There should be no significant abnormality.
The indications should be clear.
L.C
Less than initial limit
ΔC / C
Within ±10%of initial value
tanδ
Less than initial limit
Loading at Appearance There should be no significant abnormality.
High
The indications should be clear.
temperature _L.C
Less than initial limit
ΔC / C
TCFGA1A226M8R : Within ±15% of initial value
TCFGA0J476M8R : Within ±15% of initial value
TCFGA0G686M8R : Within ±15% of initial value
Others
: Within ±10% of initial value
tanδ
Less than initial limit
Terminal Capacitance The measured value should be stable.
Strength _{Appearance There should be no significant abnormality.}
Test conditions
(based on JIS C5101-1 and JIS C5101-3)
As per 4.29 JIS C 5101-1
As per 4.13 JIS C 5101-3
As per 4.26 JIS C 5101-1
As per 4.14 JIS C 5101-3
Apply the specified surge voltage via the serial
resistance of 1kΩ every 5±0.5min.
for 30±5 s. each time in the atmospheric condition
of 85±2°C.
Repeat this procedure 1,000 times.
After the specimens, leave it at room temperature
for over 24h and then measure the sample.
As per 4.23 JIS C 5101-1
As per 4.15 JIS C 5101-3
After applying the rated voltage for 2000+72/0h
without discontinuation via the serial resistance
of 3Ω or less at a temperature of 85±2°C, leave
the sample at room temperature/humidity for
over 24h and measure the value.
As per 4.35 JIS C 5101-1
As per 4.9 JIS C 5101-3
A force is applied to the terminal until it bends
to 1mm and by a prescribed tool maintain the
condition for 5s. (See the figure below.)
20
50
(Unit : mm)
F (Apply force)
R230
1
Thickness 1.6mm
Adhesiveness
The terminal should not come off.
45 45
As per 4.34 JIS C 5101-1
As per 4.8 JIS C 5101-3
Apply force of 5N in the two directions shown
in the figure below for 10±1s after mounting
the terminal on a circuit board.
product
Apply force
a circuit board
www.rohm.com
4/7
○^c 2010 ROHM Co., Ltd. All rights reserved.
2010.01 - Rev.G