English
Language : 

BD9132MUV Datasheet, PDF (4/17 Pages) Rohm – Output 2A or More High Efficiency Step-down Switching Regulator with Built-in Power MOSFET
●Information on advantages
Advantage 1:Offers fast transient response with current mode control system.
Conventional product (Load response IO=1A→3A)
BD9132MUV (Load response IO=1A→3A)
VOUT
145mV
VOUT
62mV
IOUT
IOUT
Voltage drop due to sudden change in load was reduced by about 50%.
Fig.18 Comparison of transient response
Advantage 2: Offers high efficiency for all load range.
・For lighter load:
Utilizes the current mode control mode called SLLM for lighter load, which reduces various dissipation such as switching
dissipation (PSW), gate charge/discharge dissipation, ESR dissipation of output capacitor (PESR) and on-resistance
dissipation (PRON) that may otherwise cause degradation in efficiency for lighter load.
Achieves efficiency improvement for lighter load.
・For heavier load:
Utilizes the synchronous rectifying mode and the low on-resistance MOS FETs incorporated as power transistor.
ON resistance of Highside MOS FET : 82mΩ(Typ.)
ON resistance of Lowside MOS FET : 70mΩ(Typ.)
Achieves efficiency improvement for heavier load.
Offers high efficiency for all load range with the improvements mentioned above.
100
SLLM
②
50 ① PWM
①inprovement by SLLM system
②improvement by synchronous rectifier
0
0.001 0.01
0.1
1
Output current Io[A]
Fig.19 Efficiency
Advantage 3:・Supplied in smaller package due to small-sized power MOS FET incorporated.
・Output capacitor Co required for current mode control: 22μF ceramic capacitor
・Inductance L required for the operating frequency of 1 MHz: 2.2μH inductor
・Incorporates FET + Boot strap diode
Reduces a mounting area required.
EN
VREF
VCC
Gm Amp
+
Soft
Start
Current
Comp
+ RQ
S
SLOPE
CLK
OSC
VCC
UVLO
TSD
SCP
Current
Sense/
Protect
+
Driver
Logic
ADJ
R1 R2
ITH
RITH CITH
VCC
BST
PVCC
SW
PVCC
PGND
GND
3.3V
Input
Output
15mm
Fig.20 Example application
R2
R1
RITH
CITH
20mm
Cf
CBST
Rf
L
CIN
Co
4/16