BD37523FS_15 Datasheet, PDF (4/31 Pages) Rohm – Sound Processor with Built-in 2-band Equalizer

BD37523FS
Absolute Maximum Ratings (Ta=25°C)
Parameter
Symbol
Rating
Unit
Power supply Voltage
VCC
10.0
V
Input voltage
VIN
VCC+0.3 to GND-0.3
V
Power Dissipation
Pd
1 ^{(Note 1)}
W
Storage Temperature
Tstg
-55 to +150
°C
(Note 1) When mounted on standard board (70 x 70 x 1.6(mm³)), derate by 8mW/°C for Ta above25°C.
Thermal resistance θja = 125(°C/W)
Material: A FR4 grass epoxy board(3% or less of copper foil area)
Caution: Operating the IC over the absolute maximum ratings may damage the IC. The damage can either be a short circuit between pins or an open circuit
between pins and the internal circuitry. Therefore, it is important to consider circuit protection measures, such as adding a fuse, in case the IC is operated
over the absolute maximum ratings
Recommended Operating Conditions
Parameter
Symbol
Min
Typ
Max
Unit
Power Supply Voltage
VCC
7.0
－
9.5
V
Temperature
Topr
-40
－
+85
°C
Electrical Characteristics
(Unless otherwise noted, Ta=25°C, VCC=8.5V, f=1kHz, VIN =1Vrms, Rg=600Ω, RL=10kΩ, A1 input, Input gain 0dB,
Mute OFF, Volume 0dB, Tone control 0dB, Loudness 0dB, LPF OFF, Fader 0dB)
Limit
Parameter
Symbol
Min
Typ Max
Unit
Conditions
Circuit Current (No Signal)
IQ
－
38
48
mA No signal
Voltage Gain
GV
-1.5
0
+1.5
dB GV=20log(VOUT/VIN)
Channel Balance
CB
-1.5
0
+1.5
dB CB = GV1-GV2
Total Harmonic Distortion 1
(FRONT,REAR)
THD+N1 － 0.001 0.05
％
VOUT=1Vrms
BW=400Hz-30KHz
Total Harmonic Distortion 2
(SUBWOOFER)
Output Noise Voltage 1
(FRONT,REAR) *
Output Noise Voltage 2
(SUBWOOFER) *
THD+N2 － 0.002 0.05
％
VOUT=1Vrms
BW=400Hz-30KHz
VNO1
－
3.8
15
μVrms
Rg = 0Ω
BW = IHF-A
VNO2
－
4.8
15
μVrms
Rg = 0Ω
BW = IHF-A
Residual Output Noise Voltage *
Crosstalk Between Channels *
Ripple Rejection
Input Impedance(A, B)
Input Impedance (C,D,E)
VNOR
CTC
RR
RIN_S
RIN_D
Fader = -∞dB
－
1.8
10 μVrms _{Rg = 0Ω}
BW = IHF-A
Rg = 0Ω
－
-100 -90
dB CTC=20log(VOUT/VIN)
BW = IHF-A
f=1kHz
－
-70
-40
dB VRR=100mVrms
RR=20log(VCC IN/VOUT)
70
100
130
kΩ
175
250
325
kΩ
Maximum Input Voltage
Crosstalk Between Selectors *
VIM
CTS
2.1
2.3
－
Vrms ^{VIM at THD+N(VOUT)=1ï¼}
BW=400Hz-30KHz
Rg = 0Ω
－
-100 -90
dB CTS=20log(VOUT/VIN)
BW = IHF-A
CP1 and CN input
Common Mode Rejection Ratio * CMRR
50
65
－
dB ^{CP2 and CN input}
CMRR=20log(VIN/VOUT)
BW = IHF-A
www.rohm.com
© 2015 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
4/27
TSZ02201-0C2C0E100480-1-2
16.Dec.2015 Rev.001