BU97931FV-LB Datasheet, PDF (24/32 Pages) Rohm – Multifunction LCD Segment Driver

BU97931FV-LB MAX 112 segments (SEG28×COM4)
Datasheet
Attention about input port pull down
Satisfy the following sequence if input terminals are pulled down by external resistors (In case MPU output Hi-Z).
CSB
Date transaction period with MPU
Input "L"
period
Input"Hi-Z"
period
SD
SCL
Figure 19. Recommended Sequence when Input Ports are Pulled Down
BU97931FUV-LB adopts a 5V tolerant I/O for the digital input. This circuit includes a bus-hold function to keep HIGH level.
A pull down resistor of below 10KΩ shall be connected to the input terminals for transitions from HIGH to LOW because the
bus-hold transistor turns on during the input’s HIGH level. (Refer to the Figure 5; I/O Equivalent Circuit)
A higher resistor than 10KΩ(approximate) causes input terminals being steady by intermediate potential between HIGH and
LOW level so unexpected current is consumed by the system.
The potential depends on the pull down resistance and bus-hold transistor’s resistance.
As the bus-hold transistor turns off upon the input level is cleared to LOW, a higher resistor can be used as a pull down
resistor if MPU sets SD and SCL lines to LOW before it releases the lines.
The LOW period preceding MPU’s bus release shall be at least 50ns as same as a minimum CLK width ( tSLW ).
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ22111ï½¥15ï½¥001
24/29
TSZ02201-0P4P0D300490-1-2
26.Feb.2014 Rev.002