PML10_1111 Datasheet, PDF (2/4 Pages) Rohm – Ultra-low Ohmic Resistors for Current Detection(Wide terminal type)

PML10
Characteristics
Item
Resistance
Guaranteed value
Resistor type
G : ±2%
J : ±5%
Data Sheet
Test conditions (JIS C 5201-1)
JIS C 5201-1 4.5
Measuring method : Measure under
terminations by 4 probes.
Fig.2 (Under terminations)
probes
Variation of resistance
with temperature
Overload
Solderability
Resistance to
soldering heat
Rapid change of
temperature
Damp heat, steady state
Endurance at 70°C
Endurance
Component Solvent
Resistance
Bend strength of
the end face plating


See Table.1
± 2.0%
A new uniform coating of minimum of
95% of the surface being immersed
and no soldering damage.
± 1.0%
No remarkable abnormality on the appearance.
± 1.0%
± 3.0%
± 3.0%
± 3.0%
± 0.5%
Without open.
JIS C 5201-1 4.8
Measurement : +25 / −55 / +25 / +125°C
JIS C 5201-1 4.13
Rated voltage (current) ×2.5, 2s.
JIS C 5201-1 4.17
Rosin·Ethanol (25%WT)
Soldering condition : 235±5°C
Duration of immersion : 2.0±0.5s.
JIS C 5201-1 4.18
Soldering condition : 260±5°C
Duration of immersion : 10±1s.
JIS C 5201-1 4.19
Test temp. : −55°C to +125°C 5cyc
JIS C 5201-1 4.24
40°C, 93%RH
Test time : 56days
JIS C 5201-1 4.25.1
70°C, Rated power
1.5h : ON − 0.5h : OFF
Test time : 1,000h to 1,048h
JIS C 5201-1 4.25.3
155°C
Test time : 1,000h to 1,048h
JIS C 5201-1 4.29
23°C±5°C
Solvent : 2-propanol
JIS C 5201-1 4.33

www.rohm.com
2/3
○^c 2011 ROHM Co., Ltd. All rights reserved.
2011.10 Rev.B