ESR01 Datasheet, PDF (2/4 Pages) Rohm – Anti-surge thick film chip resistor

ESR01
Characteristics
Item
Resistance
Variation of resistance
with temperature
Overload
Solderability
Resistance to
soldering heat
Rapid change of
temperature
Damp heat, steady state
Endurance at 70°C
Endurance
Resistance to solvent
Bend strength of
the end face plating
Static electric
characteristics
Data Sheet
Guaranteed value
Resistor type
J : ±5%
F : ±1%
See Table.1
± (2.0%+0.1Ω)
A new uniform coating of minimum of
95% of the surface being immersed
and no soldering damage.
± (1.0%+0.05Ω)
No remarkable abnormality on the appearance.
± (1.0%+0.05Ω)
± (3.0%+0.1Ω)
± (3.0%+0.1Ω)
± (3.0%+0.1Ω)
± (1.0%+0.05Ω)
± (1.0%+0.05Ω)
Without mechanical damage such as breaks.
± (5.0%+0.05Ω)
Test conditions (JIS C 5201-1)
JIS C 5201-1 4.5
JIS C 5201-1 4.8
Measurement : +25 / +125°C
JIS C 5201-1 4.13
Rated voltage (current) ×2.0, 2s.
Maximum overload voltage : 100V
JIS C 5201-1 4.17
Rosin·Ethanol (25%WT)
Soldering condition : 235±5°C
Duration of immersion : 2.0±0.5s.
JIS C 5201-1 4.18
Soldering condition : 260±5°C
Duration of immersion : 10±1s.
JIS C 5201-1 4.19
Test temp. : −55°C to +125°C 1000cyc
JIS C 5201-1 4.24
40°C, 93%RH
Test time : 1,000h to 1,048h
JIS C 5201-1 4.25.1
Rated voltage (current), 70°C
1.5h : ON − 0.5h : OFF
Test time : 1,000h to 1,048h
JIS C 5201-1 4.25.3
155°C
Test time : 1,000h to 1,048h
JIS C 5201-1 4.29
23±5°C, Immersion cleaning, 5±0.5min.
Solvent : 2-propanol
JIS C 5201-1 4.33
EIAJ ED-4701 / 300 Test method 304
Voltage : 2kV
R : 1.5kΩ
C : 100pF
Apply cycle : 1 time
Dimensions (Unit : mm)
1
6
0.2±0.1
2
3
0.25
+0.05
−0.1
1.0±0.05
4
5
No.
Material
1 Resistive element (Oxide metal thick film)
2 Thin film electrode
3 Nickel electrode
4 Sn electrode
5 Alumina substrate
6 Overcoating (Resin)
6
Marking
www.rohm.com
2/3
○^c 2010 ROHM Co., Ltd. All rights reserved.
2010.08 - Rev.A