BU7242YFVM-C Datasheet, PDF (2/26 Pages) Rohm – Input/Output Full Swing Low Supply Current CMOS Operational Amplifier

BU7242YFVM-C
Block Diagram
VDD
IN+
IN-
Vbias
Class
AB control
Datasheet
OUT
VSS
Vbias
Figure 1. Block Diagram
Absolute Maximum Ratings (T_A=25°C)
Parameter
Symbol
Rating
Unit
Supply Voltage
Power Dissipation
Differential Input Voltage ^{(Note 4)}
VDD-VSS
7
V
PD
0.58 ^{(Note 2,3)}
W
VID
VDD - VSS
V
Input Common-mode Voltage Range
Input Current ^{(Note 5)}
Operating Supply Voltage
Operating Temperature
VICM
(VSS - 0.3) to (VDD + 0.3)
V
II
±10
mA
Vopr
1.8 to 5.5
±0.9 to ±2.75
V
Topr
-40 to +125
°C
Storage Temperature
Tstg
-55 to +150
°C
Maximum Junction Temperature
Tjmax
150
°C
(Note 2) To use at temperature above TA=25C reduce 4.7mW/°C.
(Note 3) Mounted on an FR4 glass epoxy PCB 70mm×70mm×1.6mm (Copper foil area less than 3%).
(Note 4) The voltage difference between inverting input and non-inverting input is the differential input voltage
The input pin voltage is set to more than VSS.
(Note 5) An excessive input current will flow when input voltages of more than VDD+0.6V or less than VSS-0.6V are applied.
The input current can be set to less than the rated current by adding a limiting resistor.
Caution: Operating the IC over the absolute maximum ratings may damage the IC. The damage can either be a short circuit between pins or an open circuit
between pins and the internal circuitry. Therefore, it is important to consider circuit protection measures, such as adding a fuse, in case the IC is
operated over the absolute maximum ratings.
www.rohm.com
© 2016 ROHM Co., Ltd. All rights reserved.
TSZ22111ï½¥15ï½¥001
2/22
TSZ02201-0GLG0G200810-1-2
12.Jul.2016 Rev.001