BD9876AEFJ Datasheet, PDF (17/24 Pages) Rohm – Flexible Step-down Switching Regulators with Built-in Power MOSFET

BD9876AEFJ
Datasheet
●Application Components Selection Method
(1) Inductor
Something of the shield Type that Fulfills the Current Rating (Current value Ipecac below), with low DCR (Direct Current
Resistance element) is recommended.
Value of Inductor influences Inductor Ripple Current and becomes the cause of Output Ripple.
In the same way as the formula below, this Ripple Current can be made small for as big as the L value of Coil or as high
as the Switching Frequency.
Ipeak =Iout + ⊿IL/2 [A]
(1)
Vin-Vout
Vout
1
⊿IL=
L
×
×
Vin
f ^[A]
(2)
(η: Efficiency, ⊿IL: Output Ripple Current, f: Switching Frequency)
Δ IL
Figure 46. Inductor Current
For design value of Inductor Ripple Current, please carry out design tentatively with about 20%～50% of Maximum Input
Current.
※When current that exceeds Coil rating flows to the coil, the Coil causes a Magnetic Saturation, and there are cases
wherein a decline in efficiency, oscillation of output happens. Please have sufficient margin and select so that Peak
Current does not exceed Rating Current of Coil.
(2) Output Capacitor
In order for Capacitor to be used in Output to reduce Output Ripple, Low Ceramic Capacitor of ESR is recommended.
Also, for Capacitor Rating, on top of putting into consideration DC Bias Characteristics, please use something whose
Maximum Rating has sufficient margin with respect to the Output Voltage.
Output Ripple Voltage is looked for using the following formula.
1
Vpp=⊿IL×
＋ ⊿IL×R_ESR [V] ・・・ (3)
2π×f×Co
Please design in a way that it is held within Capacity Ripple Voltage.
(3) Output Voltage Setting
ERROR AMP internal Standard Voltage is 1.0V. Output Voltage is determined as seen in (4) formula.
VOUT
R1
ERROR AMP
FB
R2
(R1+R2)
Vo=
×1.0 [V] ・・・ (4)
R2
VREF
1.0V
Figure 47.Voltage Return Resistance Setting Method
(4) Bootstrap Capacitor
Please connect from 0.01µF (Laminate Ceramic Capacitor) between BST Pin and Lx Pins.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
17/21
TSZ02201-0Q1Q0AJ00170-1-2
28.JAN.2014 Rev.003