|
BD93941EFV Datasheet, PDF (14/30 Pages) Rohm – LED pin rating 60V | |||
|
◁ |
BD93941EFV BD93941FP
Datasheet
OVP/SCP Settings
OVP pin is DC/DC output voltageâs over voltage protection and short circuit protection input pin.
OVP pin is a high impedance pin with no pull down resistor. Thus, at OPEN state please set the voltage
input settings using voltage dividing resistor and such.
Respective OVP pin protection conditions are as below
Protection
Name
Detection
Pin
Detection Cancellation
Timer
Condition
Condition Operations
Protection Type
OVP
SCP
OVP
OVP>3.0V
OVP<2.9V
No
OVP
OVP<0.1V
OVP>0.1V
Yes
DCDC stops during
detection
All latch
âOVP Detection Setting
VOUT abnormally increaseãvoltage detected by OVP, VOVPDET,
R1,R2 settings are as follows
R1 ï½ R2[kï]ï´ (VOVPDET[V ] ï 3.0[V ]) [kï]
3.0[V ]
âOVP Cancellation Setting
R1,R2 set from above equation,
OVP cancellation voltage VOVPCAN equals to
VOVPCAN
ï½
2.9V
ï´
(R1[kï] ï« R2[kï])
R2[kï]
[V ]
Figure 15. OVP/SCP setting example
âSCP Detection Setting
When R1,R2 are set using values obtained above, SCP voltage setting is VSCPDET is as follows
VSCPDET
ï½
0.1V
ï´
(R1[kï] ï« R2[kï])
R2[kï]
[V ]
ãSetting Exampleã
VOUT at normal operation 56VãOVP detection voltage VOVPDET=68VãR2=10k, R1 is as follows
R1 ï½ R2[kï]ï´ (VOVPDET [V ] ï 3.0[V ]) ï½10[kï]ï´ (68[V ] ï 3[V ]) ï½ 216.7 [kï]
3.0[V ]
3[V ]
When R1, R2 are set at these values, OVP cancellation voltage, VOVPCAN
VOVPCAN
ï½ 2.9[V ]ï´ (R1[kï] ï« R2[kï])
R2[kï]
ï½ 2.9[V ]ï´10[kï] ï« 216.7[kï] [V ]ãï½ 65.7
10[kï]
[V ]
In addition, at this R1, R2, SCP detection voltage
VSCPDET
ï½ 0.1[V ] ï´
(R1[kï] ï« R2[kï])
R2[kï]
ï½ 0.1[V ] ï´ 10[kï] ï« 216.7[kï][V ]ãï½ 2.27
10[kï]
[V ]
To select DC/DC components, give consideration to IC variations as well as individual component variations,
and then conduct thorough verification on practical systems.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ22111ã»15ã»001
14/27
TSZ02201-0F1F0C100270-1-2
10.Oct.2013 Rev.001
|
▷ |