RPM882-H12 Datasheet, PDF (1/10 Pages) Rohm – IrDA Infrared Communication Module

Photo Link Module
RPM882-H12
IrDA Infrared Communication Module
RPM882-H12
RPM882-H12 is an infrared communication module for IrDA Ver. 1.2 (Low Power). The infrared LED, PIN photo diode,
LSI are all integrated into a single package. This module is designed with power down function and low current
consumption at stand-by mode. The ultra small package makes it a perfect fit for mobile devices.
zFeatures
1) Infrared LED, PIN photo diode, LED driver & Receiver frequency formation circuit built in. Improvement of EMI noise
protection because of Shield Case.
2) Applied to SIR (2.4 to 115.2kbps)
3) Surface mount type.
4) Power down function built in.
5) Low voltage operation as 1.5V of interface terminals to controller (TXD, RXD, PWDOWN, TX-RC).
6) Infrared remote control transmission driver built-in.
zApplications
Mobile phone, PDA, DVC, Digital Still Camera, Printer, Handy Terminal etc.
zAbsolute maximum ratings (Ta=25°C)
Parameter
Symbol
Limits
Unit
Supply voltage
Vmax
7.0^∗1
V
Input voltage
Vin (4, 5, 6, 7pin) −0.3 to VIO+0.3
V
Operation temperature
Topr
−25 to +85
°C
Storage temperature
Tstg
−30 to +100
°C
LED peak current
Power dissipation
IFP
300^∗2
mA
Pd
300^∗3
mW
∗1 This applies to all pins basis ground pins (1pin)
∗2 LED Peak Current< 90µs, On duty 50%
∗3 When glass-epoxy board (70 70 1.6mm) mounted. In case operating environment is over 25°C,
4mW would be reduced per each 1°C stepping up.
zRecommended operating conditions (Ta=25°C)
Parameter
Symbol Min. Typ. Max. Unit
Supply voltage
VCC
2.4
3.0
3.6
V
Interface supply voltage
VIO
1.5
3.0
VCC
V
LED supply voltage
VLEDVCC 2.6
3.0
5.5
V
1/9