MNR18_1 Datasheet, PDF (1/5 Pages) Rohm – Chip resistor networks

Resistors
Chip resistor networks
MNR18 (0603×8 size)
MNR18
zFeatures
1) Suitable for damping resistors.
2) Convex electrodes
Easy to check the fillet after soldering is finished.
3) High-density mounting
Can be mounted even densely than eight 0402 chips (MCR01), and mounting costs are lower.
4) Compatible with a wide range of mounting machines.
Squared corners make it excellent for mounting using image recognition machines.
5) ROHM resistors have approved ISO-9001 certification.
Design and specifications are subject to change without notice. Carefully check the specification sheet supplied with
the product before using or ordering it.
zRatings
Item
Rated power
Conditions
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70°C.
100
80
60
40
20
0 _−55
0
70 100 125
AMBIENT TEMPERATURE (°C)
Fig.1
Specifications
0.063W (1 / 16W)
at 70°C
Power for a Packaging
Max 0.25W (1 / 4W)
Rated voltage
The voltage rating is calculated by the following equation. If the value
obtained exceeds the limiting element voltage, the voltage rating
is equal to the maximum operating voltage.
E= P×R
Nominal resistance
See Table 1.
Operating temperature
E : Rated voltage (V)
P : Rated power (W)
R : Nominal resistance (Ω)
Limiting element voltage
25V
−55°C to +125°C
Jumper type
Resistance
Max. 50mΩ
Rated current
1A
Power for a Packaging
Max 0.25W (1 / 4W)
Operating temperature −55°C to +125°C
Table 1
Resistance tolerance
Resistance range
(Ω)
Resistance temperature coefficient
(ppm / °C)
J (±5%)
10≤R≤1M (E24)
±200
∗Before using components in circuits where they will be exposed to transients such as pulse loads(short-duration, high-level loads),
be certain to evaluate the component in the mounted state. In addition, the reliability and performance of this component cannot be
guaranteed if it is used with a steady state voltage that is greater than its rated voltage.
Rev.B
1/4