KTR03 Datasheet, PDF (1/4 Pages) Rohm – High Voltage Resistance Chip Resistors

Resistors
KTR03
High Voltage Resistance Chip Resistors
KTR03 (0603 size : 1 / 10W)
zFeatures
1) Power rating of 1 / 10W
2) Limiting element voltage of KTR series is 7 times compared with that of MCR series.
3) Highly reliable chip resistor
Ruthenium oxide dielectric offers superior resistance to the elements.
4) ROHM resistors have approved ISO9001- / ISO/TS 16949- certification.
Design and specifications are subject to change without notice. Carefully check the specification sheet before using or
ordering it.
zRatings
Item
Rated power
Conditions
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70°C.
100
Specifications
0.10W (1 / 10W)
at 70°C
80
60
40
20
0
−55
0
70 100
155
AMBIENT TEMPERATURE (°C)
Fig.1
Rated voltage
The voltage rating is calculated by the following equation.
If the value obtained exceeds the limiting element voltage,
the voltage rating is equal to the maximum operating voltage.
E= P×R
Nominal resistance See Table 1.
Operating temperature
E: Rated voltage (V)
P: Rated power (W)
R: Nominal resistance (Ω)
Limiting element voltage 350V
−55°C to + 155°C
Table 1
Resistance tolerance
F (±1%)
J (±5%)
Resistance range
(Ω)
10 ≤ R ≤ 10M (E24)
10 ≤ R ≤ 10M (E24)
Resistance temperature coefficient
(ppm/°C)
±100
±200
zBefore using components in circuits where they will be exposed to transients such as pulse loads (short–duration, high– level loads), be certain to evaluate the
component in the mounted state. In addition, the reliability and performance of this component cannot be guaranteed if it is used with a steady state voltage that
is greater than its rated voltage.
Rev.A
1/3