BUXXTA2WNVX Datasheet, PDF (1/28 Pages) Rohm – High-speed Load Response FULL CMOS LDO Regulators

CMOS LDO Regulator Series for Portable Equipments
High-speed
Load Response
FULL CMOS LDO Regulators
BUTA2WNVX Series, BUTA2WHFV Series
No.09020EAT01
●Description
BU□□TA2WNVX /HFV series is high-performance FULL CMOS regulator with 200-mA output, which is mounted on
microminiature package SSON004X1216 (1.2 mm  1.6 mm  0.6 mm) &HVSOF5(1.6mm X 1.6mm X0.6mm). It has
excellent noise characteristics and load responsiveness characteristics despite its low circuit current consumption of 40 A.
It is most appropriate for various applications such as power supplies for logic IC, RF, and camera modules.
Microminiature package SSON004X1216 & HVSOF5 with built-in heatsink is adopted for the package, which contributes to
the space-saving design of the set.
●Features
1) High-accuracy output voltage of 1% (25 mV on 1.5-V & 1.8-V products）
2) High ripple rejection: 70 dB (Typ., 1 kHz, VOUT1.8 V))
3) Compatible with small ceramic capacitor (CIN=Co=1.0 F)
4) Low current consumption: 40 A
5) ON/OFF control of output voltage
6) With built-in overcurrent protection circuit and overheat protection circuit
7) With built-in output discharge circuit
8) Adopting microminiature power package SSON004X1216
●Applications
Battery-powered portable equipment, etc.
 Absolute maximum rating
Parameter
Symbol
Limits
Unit
Maximum applied power voltage
VMAX
-0.3 ~ +6.5
V
220*¹
Power dissipation
Pd1
(SSON004X1216)
mW
Pd2 410*² (HVSOF5)
mW
Maximum junction temperature
TjMAX
+125
°C
Operational temperature range
Topr
-40 ~ +85
°C
Storage temperature range
Tstg
-55 ~ +125
°C
*1 When 1 PCB (70 mm  70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented.
Reduced to 2.2 mW/C when used at Ta=25C or higher.
*2 When 1 PCB (70 mm  70 mm, thickness 1.6-mm glass epoxy) a standard ROHM board is implemented.
Reduced to 4.1 mW/C when used at Ta=25C or higher.
 Recommended operating range (Do not exceed Pd.）
Parameter
Symbol
Limits
Unit
Input power supply voltage
VIN
2.5 ~ 5.5
V
Maximum output current
IMAX
200
mA
 Recommended operating conditions
Parameter
Input capacitor
Output capacitor
Symbol
CIN
CO
Min. Typ. Max. Unit
Conditions
0.5*³ 1.0
－
μF A ceramic capacitor is recommended.
0.5*³ 1.0
－
μF A ceramic capacitor is recommended.
*3 Set the capacity value of the capacitor so that it does not fall below the minimum value, taking temperature characteristics,
DC device characteristics, and change with time into consideration.
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
1/27
2009.05 - Rev.B