|
BH7881EFV_10 Datasheet, PDF (1/10 Pages) Rohm – 2W + 2W Stereo Speaker / Headphone Amplifier | |||
|
Class-AB Speaker Amplifiers
2W + 2W Stereo
Speaker / Headphone Amplifier
BH7881EFV
No.10077EAT05
âDescription
The BH7881EFV is a low voltage, low noise, high output speaker/headphone amplifier IC, in which a Bi-CMOS process is
used. An on-chip speaker amplifier circuit that is capable of 2W+2W output can be used as a headphone amplifier by
switching the operating mode. This makes it possible to configure an audio system using few external devices.
With a built-in, low saturation regulator with programmable output voltage and output current, clear tone quality is obtained
even when directly connected to a digital power supply. A peripheral analog circuit can also be regulator driven. Furthermore,
the BH7881EFV provides speaker output and VREG output short-circuit detection functions, a thermal shutdown function with
hysteresis, and a speaker protection function.
âFeatures
1) Built-in low saturation type regulator (Digital power supply driver, voltage and current variable, short circuit detection)
2) Bass boost mode, gain switching functions
3) Speaker MUTE function (Headphone mode)
4) Built-in line amplifier output (gain adjustment, LPF setting) active/suspend function (TTL input control pin)
5) Hysteretic thermal shutdown function (Set for approximately 150â /90â)
6) IC protection function (SP pin VCC/GND short circuit detection)
7) Speaker protection function (Output voltage amplitude control)
âApplications
Notebook computers, LCD TVs, etc.
âAbsolute maximum ratings (Ta=25â)
Parameter
Ratings
Unit
Supply voltage
+6.0
V
Power dissipation
1100 *1
mW
Storage temperature
-55ï½+125
â
Operating temperature
-10ï½+70
â
*1 Reduced by 11 mW/â at 25â or higher, when mounting on a 70mmX70mmX1.6mm PCB board).
âOperating Conditions (Ta=25â)
Parameter
Ratings
Unit
Supply voltage
+3.3ï½+5.5
V
* This IC is not designed to be radiation-resistant.
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
1/9
2010.06 - Rev.A
|
▷ |