BH6173GUL Datasheet, PDF (1/5 Pages) Rohm – Silicon Monolithic Integrated Circuit

Structure
Product
Type
Functions
Silicon Monolithic Integrated Circuit
Power Management LSI for MultiMedia LSI on Cellular
BH6174GUL
・2ch 600mA, high efficiency Step-down Converter. (16 steps adjustable VO by I2C)
・5-ch 300mA, CMOS-type LDOs. Power-Save mode supported. (16 steps adjustable VO by I2C)
・LDO and Step-down converter Power ON/OFF control enabled by I2C interface or external pin
・I2C compatible Interface. (Device address is “1001111”)
・Discharge resistance selectable for power-down sequence ramp speed control
・Wafer Level CSP package(2.8mm×2.8mm) for space-constrained applications
・0.5mm thin package to meet ultra-thin design requirements
・Step-down Converter output loop back available for LDO power supply (LDO3,4)
Absolute Maximum Ratings（Ta=25C）
Parameter
Symbol
Maximum Supply Voltage (VBAT1,VBAT2, PBAT)
VBATMAX
Maximum Supply Voltage (PBAT1, PBAT2)
VPBATMAX
Maximum Supply Voltage (VIN34)
V34MAX
Maximum Supply Voltage (DVDD)
VDVDDMAX
Maximum Input Voltage 1
(LX1, FB1, LX2, FB2, OUT1, OUT2, OUT3, OUT4, OUT5,
Maximum Input Voltage 2(NRST, CLK, DATA)
VINMAX1
VINMAX2
Power Dissipation
Pd
Operating Temperature Range
Topr
Storage Temperature Range
Tstg
*1 This is the allowable loss of when it is mounted on a ROHM specification board 50mm×58mm.
When a substrate is implemented, the allowable loss varies from the size and material of the substrate.
To use at temperature higher than 25C, derate 9.6mV per 1C.
Rating
6.0
6.0
6.0
4.5
VBAT + 0.3
DVDD + 0.3
960*¹
-35 ～ +85
-55 ～ +125
Recommended Operating Conditions (Ta=25C)
Parameter
VBAT1, 2 Voltage
PBAT1, 2 Voltage
VIN34 Voltage
DVDD Voltage
Symbol
Range
Unit
VBAT
*² 2.60 ~ 5.50
V
VPBAT
*² 2.60 ~ 5.50
V
V34
*³ 1.70 ~ 5.50
V
VDVDD
*⁴ 1.70 ~ 3.60
V
*2 Whenever the VBAT or PBAT or VIN34 voltage is under the LDO or SWREG output voltage,
the LDO and SWREG output is not guaranteed to meet its published specifications.
*3 VIN34 Power Supply can be externally connected to the VBAT and PBAT Power Supply when necessary.
*4 The DVDD Voltage must be under the Battery Voltage VBAT, PBAT at any times.
* This product is not especially designed to be protected from radioactivity.
1/4
Unit
V
V
V
V
V
V
mW
℃
℃
REV. B