BA6110FS Datasheet, PDF (1/7 Pages) Rohm – Voltage controlled operational amplifier

Standard ICs
BA6110FS
Voltage controlled operational amplifier
BA6110FS
The BA6110FS is a low-noise, low-offset programmable operational amplifier. Offering superb linearity over a broad
range, this IC is designed so that the forward direction conductivity (gm) can be changed, making it ideal for applications
such as voltage control amplifiers (VCA), voltage control filters (VCF) and voltage control oscillators (VCO).
Distortion reduction circuitry improves the signal-to-noise ratio by a significant 10dB at a distortion rate of 0.5% in
comparison with products not equipped with this feature. When used as a voltage control amplifier (VCA), a high S / N
ratio of 86dB can be achieved at a distortion rate of 0.5%.
The open loop gain is determined by the control current and an attached gain determining resistance RL, enabling a wide
range of settings.
In addition, a built-in low-impedance output buffer circuit reduces the number of attachments.
!Applications
Electronic volume controls
Voltage-controlled impedances
Voltage-controlled amplifiers (VCA)
Voltage-controlled filters (VCF)
Voltage-controlled oscillators (VCO)
Multipliers
Sample holds
Schmitt triggers
!Features
1) Low distortion rate.
(built-in distortion reduction bias diode)
2) Low noise.
3) Low offset voltage. (VIO = 3m VMax).
!Block diagram
BA6110FS
4) Built-in output buffer.
5) Variable gm with superb linearity across three decade
fields.
16
15
14
13
12
11
10
9
1/2
–
+
BUFFER
1/2
VCC
1
2
3
4
5
6
7
8