R1122N_17 Datasheet, PDF (4/21 Pages) RICOH electronics devices division – LOW NOISE 150mA LDO REGULATOR

R1122N
ELECTRICAL CHARACTERISTICS
• R1122Nxx1A
Topt=25°C
Symbol
VOUT
Item
Output Voltage
IOUT
Output Current
ΔVOUT/ΔIOUT Load Regulation
VDIF
Dropout Voltage
Conditions
Min. Typ. Max.
VIN = Set VOUT + 1V
1mA ^<= IOUT ^<= 30mA
VIN = Set VOUT + 1V
When VOUT = Set VOUT -0.1V
VIN = Set VOUT + 1V
1mA ^<= IOUT ^<= 80mA
VOUT
×0.98
150
VOUT
×1.02
12
40
Refer to the ELECTRICAL CHARACTERISTICS by OUTPUT VOLTAGE
Unit
V
mA
mV
ISS
Supply Current
VIN = Set VOUT + 1V
100
170
μA
Istandby
ΔVOUT/ΔVIN
RR
VIN
ΔVOUT/
ΔTopt
ISC
Supply Current (Standby)
Line Regulation
Ripple Rejection
Input Voltage
Output Voltage
Temperature Coefficient
Short Current Limit
VIN = VCE = Set VOUT + 1V
Set VOUT+0.5V ^<= VIN ^<= 6.0V
IOUT = 30mA
f = 1kHz, Ripple 0.5Vp-p
VIN = Set VOUT + 1V
IOUT = 30mA
−40°C ^<= Topt ^<= 85°C
VOUT = 0V
0.1
1.0
μA
0.05
0.20
%/V
80
dB
2.0
6.0
V
±100
ppm/°C
30
mA
RPU
VCEH
VCEL
en
CE Pull-up Resistance
CE Input Voltage “H”
CE Input Voltage “L”
Output Noise
BW=10Hz to 100kHz
2.5
5.0
10.0
MΩ
1.5
VIN
V
0.00
0.25
V
30
μVrms
RECOMMENDED OPERATING CONDITIONS (ELECTRICAL CHARACTERISTICS)
All of electronic equipment should be designed that the mounted semiconductor devices operate within the
recommended operating conditions. The semiconductor devices cannot operate normally over the
recommended operating conditions, even if when they are used over such conditions by momentary
electronic noise or surge. And the semiconductor devices may receive serious damage when they continue
to operate over the recommended operating conditions.
4