R2061L01-E2 Datasheet, PDF (39/60 Pages) RICOH electronics devices division – 3 Wire Interface Real-Time Clock ICs with Battery Backup Switch-Over Function

* R2061K (FFP12) is the discontinued product as of July, 2016.
R2061x
NO.EA-112-160701
Power-on Reset, Oscillation Halt Sensing, and Supply Voltage
Monitoring
 PON, XST, and VDET
The power-on reset circuit is configured to reset control register1, 2, and clock adjustment register when VDD
power up from 0v. The oscillation halt sensing circuit is configured to record a halt on oscillation by 32.768-kHz
clock pulses. The supply voltage monitoring circuit is configured to record a drop in supply voltage below a
threshold voltage of 2.1 or 1.35v.
Each function has a monitor bit. I.e. the PON bit is for the power-on reset circuit, and XST bit is for the oscillation
halt sensing circuit, and VDET is for the supply voltage monitoring circuit. PON and VDET bits are activated to
“H”. However, XST bit is activated to “L”. The PON and VDET accept only the writing of 0, but XST accepts
the writing of 0 and 1. The PON bit is set to 1, when VDD power-up from 0V, but VDET is set to 0, and XST is
indefinite.
The functions of these three monitor bits are shown in the table below.
Function
Address
Activated
When VDD power
up from 0v
accept the writing
PON
Monitoring for the power-
on reset function
D4 in Address Fh
High
1
0 only
XST
Monitoring for the
oscillation halt sensing
function
D5 in Address Fh
Low
indefinite
Both 0 and 1
VDET
a drop in supply voltage
below a threshold
voltage of 2.1 or 1.35v
D6 in Address Fh
High
0
0 only
The relationship between the PON, XST, and VDET is shown in the table below.
PON
0
0
0
0
1
1
XST
0
0
1
1
0
1
VDET
0
1
0
1
*
*
Conditions of supply voltage
and oscillation
Halt on oscillation, but no drop in
VDD supply voltage below
threshold voltage
Halt on oscillation and drop in VDD
supply voltage below threshold
voltage, but no drop to 0V
No drop in VDD supply voltage
below threshold voltage and no
halt in oscillation
Drop in VDD supply voltage below
threshold voltage and no halt on
oscillation
Drop in supply voltage to 0v
Instantaneous power-down
Condition of oscillator, and back-
up status
Halt on oscillation cause of
condensation etc.
Halt on oscillation cause of drop in
back-up battery voltage
Normal condition
No halt on oscillation, but drop in
back-up battery voltage
Power-up from 0v,
Time data is unreliable.
39