RH5RH301A Datasheet, PDF (3/29 Pages) RICOH electronics devices division – PWM STEP-UP DC/DC CONVERTER

RH5RH
BLOCK DIAGRAM
Lx
Vss
EXT
LxSW
VLX limiter
Buffer
PWM control
OSC
Chip Enable
Slow start
Vref
Phase Comp.
OUT
–
+
Error Amp.
CE
Error Amp. (Error Amplifier) has a DC gain of 80dB, and Phase Comp. (Phase Compensation Circuit)
provides the frequency characteristics including the 1st pole (fp=0.25Hz) and the zero point (fz=2.5kHz).
Furthermore, another zero point (fz=1.0kHz) is also obtained by the resistors and a capacitor connected to
the OUT pin.
(Note) Lx Pin ^{............only} for RH5RH××1A and RH5RH××3B
EXT Pin ^{.........only} for RH5RH××2B and RH5RH××3B
CE Pin ^{...........only} for RH5RH××3B
SELECTION GUIDE
In RH5RH Series, the output voltage, the driver, and the taping type for the ICs can be selected at the user's
request. The selection can be made by designating the part number as shown below :
RH5RH×××× – ×× ← Part Number
↑↑ ↑
ab c
Code
Description
Setting Output Voltage (VOUT):
a
Stepwise setting with a step of 0.1V in the range of 2.7V to 7.5V is possible.
Designation of Driver:
1A: Internal Lx Tr. Driver (Oscillator Frequency 50kHz)
b
2B: External Tr. Driver (Oscillator Frequency 100kHz)
3B: Internal Tr./External Tr. (selectively available) (Oscillator Frequency 100kHz, with chip
enable function)
Designation of Taping Type :
Ex. SOT-89 : T1, T2
c
SOT-89-5 : T1, T2
(refer to Taping Specifications)
“T1” is prescribed as a standard.
For example, the product with Output Voltage 5.0V, the External Driver (the Oscillator Frequency 100kHz)
and Taping Type T1, is designated by Part Number RH5RH502B-T1.
2