R1111N Datasheet, PDF (15/16 Pages) RICOH electronics devices division – LOW NOISE 150mA LDO REGULATOR

s TECHNICAL NOTES
When using these ICs, consider the following points:
In these ICs, phase compensation is made for securing stable operation even if the load current is varied. For this purpose, be
sure to use a capacitor COUT with good frequency characteristics and ESR (Equivalent Series Resistance) of which is in the
range described as follows:
3 _CE VOUT 5
R1111N301B
1 _VIN
GND
2
VIN
Ceramic Capacitor 1µF
Ceramic
Capacitor
ESR
IOUT
S.A.
Spectrum
Analyzer
Measuring Circuit for white noise;R1111N301B
The relations between IOUT (Output Current) and ESR of Output Capacitor are shown below. The conditions when the white
noise level is under 40µV(Avg.) are marked as the hatched area in the graph.
(note: When the additional ceramic capacitors are connected to the Output Pin with Output capacitor for phase
compensation, the operation might be unstable. Because of this, test these ICs with as same external components as ones to
be used on the PCB.)
<measuring conditions>
(1) VIN=4V
(2) Frequency band :10Hz to 1MHz
(3) Temperature : 25°C
R1111N301B
Ceramic 1.0µF
R1111N301B
Ceramic 2.2µF
100.0
100.0
10.0
10.0
1.0
1.0
0.1
0
50
100
150
Output Current IOUT (mA)
0.1
0
50
100
150
Output Current IOUT (mA)

Make VDD and GND line sufficient. When the impedance of these is high, the noise might be picked up or not work
correctly.

Connect the capacitor with a capacitance of 1µF or more between VDD and GND as close as possible.

Set external components, especially Output Capacitor, as close as possible to the ICs and make wiring shortest.
Rev.1.11
- 15 -