RP101_17 Datasheet, PDF (1/33 Pages) RICOH electronics devices division – Supply Current Typ. 18uA

RP101x SERIES
0.6% ACCURACY LOW NOISE 300mA LDO REGULATOR
NO.EA-167-160425
OUTLINE
The RP101x Series are CMOS-based voltage regulator ICs with high output voltage accuracy, extremely low
supply current, low ON-resistance, and high ripple rejection. Each of these ICs consists of a voltage reference
unit, an error amplifier, resistor-net for voltage setting, a current limit circuit, and a chip enable circuit.
These ICs perform with low dropout voltage and a chip enable function. The line transient response and load
transient response of the RP101x Series are excellent, thus these ICs are very suitable for the power supply for
hand-held communication equipment.
The output voltage of these ICs is fixed with high accuracy. Since the packages for these ICs are SOT-23-5 and
DFN(PLP)1612-4 (t0.6mm type) or DFN(PLP)1612-4B (t0.4mm type), therefore high density mounting of the
ICs on boards is possible.
FEATURES
 Supply Current .............................................................Typ. 18A
 Standby Current ...........................................................Typ. 0.1A
 Dropout Voltage............................................................Typ. 0.13V (IOUT150mA, VOUT2.8V)
 Ripple Rejection ...........................................................Typ. 75dB (f1kHz)
 Temperature-Drift Coefficient of Output Voltage ..........Typ. 30ppm/C
 Line Regulation ............................................................Typ. 0.02%/V
 Output Voltage Accuracy..............................................0.6%
 Packages......................................................................DFN(PLP)1612-4, DFN(PLP)1612-4B, SOT-23-5
 Input Voltage Range.....................................................1.7V to 5.25V
 Output Voltage Range ..................................................1.2V to 3.3V (0.1V steps)
(For other voltages, please refer to MARK INFORMATIONS.)
 Built-in Fold Back Protection Circuit.............................Typ. 40mA (Current at short mode)
 Ceramic capacitors are recommended to be used with this IC .... 1.0F or more
APPLICATIONS
 Power source for portable communication equipment.
 Power source for electrical appliances such as cameras, VCRs and camcorders.
 Power source for battery-powered equipment.
 Power source for home appliances.
1