|
20100-1 Datasheet, PDF (1/1 Pages) RHOPOINT COMPONENTS – Butt bonded thermocouples | |||
|
PRECISION IN ELECTRONICS
TECHNICAL DATASHEET
TEMPERATURE SENSORS
Butt bonded thermocouples 20100 series
Dimensions in mm
These thermocouples have their free filament supported on a temporary
polyimide film carrier. This is a tough, flexible and dimensionally stable
material rated at 260ËC continuous.
During installation the carrier can be peeled from the sensor or released by
the application of heat, alternatively parts of the carrier may be cut away
with scissors or a knife. Designed primarily for application with ceramic
cements. The free foil thermocouple can be easily brushed into a thin layer
of cement following application and drying of a thin insulating layer if an
ungrounded junction is required.
⢠Response time down to 1mS (grounded)
⢠Low mass giving low thermal inertia (butt bonded
construction)
⢠Flexible will bond to flat or curved surfaces
⢠May be used with any standard readout equipment
Part
number
20100-1
20100-2
20101-1
20102-2
Thermocouple
type
Type K
Type K
Type E
Type T
Foil
thickness (mm)
0.005
0.013
0.005
0.013
Leads
(mm)
0.025 x 0.76
0.05 x 0.76
0.025 x 0.76
0.05 x 0.76
Part
number
20113
20114
Thermocouple
type
Type E
Type T
Foil
thickness (mm)
0.013
0.013
Leads
(mm)
0.25
0.25
Temperature
range ËC
-160 to +815
-160 to +815
-160 to +650
-160 to +370
Temperature
range ËC
-195 to +260
-195 to +260
© Rhopoint Components Ltd, Hurst Green, Oxted, Surrey, RH8 9AX, UK
T +44 (0) 870 608 1188 sales@rhopointcomponents.com www.rhopointcomponents.com
|