GPS-EVAL2R2 Datasheet, PDF (3/4 Pages) rfsolutions.ltd – GPS MODULE EVALUATION BOARD

GPS MODULE EVALUATION BOARD
• The only connections required to the GPS Evaluation board are an RS232 data cable and power.
• Jumper link JP5 should be fitted to set the baud rate to 4800 baud.
• Please see the Microsoft Autoroute help file for information on configuring the software to work with a GPS
receiver
Evaluation Software
• This provides an interface to the GPS receiver. Information including your current Location, a real time
position plot, the satellite locations and the satellite signal strength is displayed, as shown below.
• The only connections required to the GPS Evaluation board are an RS232 data cable and power.
• All jumper connections can be left open and the communications can be effected at 9600 baud.
DS033-3 July 2004
©2004 Reg. No. 227 4001, England
Page 3