RVA2007L Datasheet, PDF (7/10 Pages) RF Micro Devices – ANALOG CONTROLLED VARIABLE GAIN AMPLIFIER

RVA2007L
Evaluation Board Bill of Materials (BOM)
Description
EVALUATION BOARD
CAP, 1 F, 10%, 10V, X5R, 0402
RES, 0 0402
CONN, SMA, END LAUNCH, UNIV, HYB MNT, FLT
CONN, HDR, ST, PLRZD, 4-PIN, 0.100”
CONN, HDR, ST, PLRZD, 2-PIN, 0.100”
DNP
RVA2007L MODULE
Reference
Designator
C7, C9 - C10
R1
J1 - J2
P2
P1
C1, C3 - C4, C6, C11 - C12,
R3 - R5
U1
Manufacturer
DDI
MURATA ELECTRONICS
KAMAYA, INC
HEILIND ELECTRONICS
ITW PANCON
ITW PANCON
RFMD
Manufacturer’s P/N
RFVAx007L410(A)
GRM155R61A105KE15D
RMC1/16SJPTH
PER MAT-21-1038
MPSS100-4-C
MPSS100-2-C
RVA2007L
Pin
1
2
3
4
5
6
7
8
Center
Pad
Function
RFIN
GND
VPC
NC
VCC
GND
RFOUT
VCTRL
GND
Pin Table and Description
Description
RF input pin. Internal DC block.
Ground pin.
Power up/down control for 2nd stage amplifier. Apply V_CC to power on 2nd stage amplifier. Apply 0 V to disable
2nd stage amplifier. Do not exceed V_CC+0.5V. Connect to V_CC if not needed. Decoupling capacitor may be
desired on application board for control line noise.
No connection.
Power supply for the module. Recommending 1 uF decoupling cap on the application board.
Ground pin.
RF output pin. Internal DC block.
Gain control voltage; 0 V to 3.3 V range. Maximum gain at 0 V. Recommending 0.1 uF decoupling on the applica-
tion board.
Center ground pads need to have a good thermal path on the application board. Use solder stencil pattern
shown in the document to define solder paste during assembly.
DS130725
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
7 of 10