RFVA2017 Datasheet, PDF (6/9 Pages) RF Micro Devices – ANALOG CONTROLLED VARIABLE GAIN AMPLIFIER

RFVA2017
Pin Function
1
RFIN
2
GND
3
VPC
4
5
6
7
8
Center
Pad
NC
VCC
GND
RFOUT
VCTRL
GND
Not
Pin Table and Description
Description
RF input pin. Internal DC block.
Ground pin.
Power up/down control for 2nd stage amplifier. Apply V_CC to power on 2nd stage amplifier. Apply 0V to disable
2nd stage amplifier. Do not exceed V_CC + 0.5V. Connect to V_CC if not needed. Decoupling capacitor may be
n desired on application board for control line noise.
No connection.
Power supply for the module. Recommending 1F decoupling cap on the application board.
ig ^{Ground pin.}
RF output pin. Internal DC block.
Gain control voltage; 0V to 3.3V range. Maximum gain at 0V. Recommending 0.1F decoupling on the applica-
s _{tion board.}
Center ground pads need to have a good thermal path on the application board. Use solder stencil pattern
De ^{shown in the document to define solder paste during assembly.}
For ^New
6 of 9
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
DS141202