RF6263 Datasheet, PDF (4/8 Pages) RF Micro Devices – 3V 900MHZ LINEAR POWER AMPLIFIER MODULE

RF6263
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Pkg
Base
Function
NC
VREG
VMODE
RF IN
VCC1
NC
NC
NC
VCC2
VCC2
VCC2
RF OUT
NC
VCC2L
NC
NC
GND
Description
Interface Schematic
No connection. Do not connect this pin to any external circuit.
Regulated voltage supply for amplifier bias circuit. In power down mode,
both V_REG and V_MODE need to be LOW (<0.5V).
For nominal operation (High Power mode), V_MODE is set LOW. When set
HIGH, devices are biased lower to improve efficiency.
RF input internally matched to 50Ω. This input is internally AC-coupled.
First stage collector supply. A 2200pF and 4.7μF decoupling capacitor are
required.
No connection. Do not connect this pin to any external circuit.
No connection. Do not connect this pin to any external circuit.
No connection. Do not connect this pin to any external circuit.
High power output stage collector supply. Refer to schematic for required
external components.
Same as pin 9.
Same as pin 9.
RF output. Internally AC-coupled.
No connection. Do not connect this pin to any external circuit.
Low power output stage collector supply. Refer to schematic for required
external components.
No connection. Do not connect this pin to any external circuit.
No connection. Do not connect this pin to any external circuit.
Ground connection. The backside of the package should be soldered to a
top side ground pad which is connected to the ground plane with multiple
vias. The pad should have a short thermal path to the ground plane.
Pin 1 ID
Package Drawing
3.00
A
1.45
Pin 1 ID
3.00
1.45
0.15 C
2 PLCS
0.15 C
2 PLCS
B
0.203 REF
00..4200TYP
0.10 M C A B
0.08 C
0.925
0.775
0.102 REF
C
Shaded areas represent pin 1. Dimensions in mm.
00..2188TYP
0.05
0.50 TYP
0.08 C
4 of 8
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
Rev A0 DS070622