RFPA0802 Datasheet, PDF (2/13 Pages) RF Micro Devices – Integrated Power Amplifier 700MHz to 950MHz

RFPA0802
Absolute Maximum Ratings
Parameter
Supply Voltage in Standby Mode
Supply Voltage in Idle Mode
Supply Voltage in Operating Mode
Supply Voltage, VBATT
Control Voltage, VEN, VMODE0, VMODE1
RF – Input Power (CW, VCC = 3.3V, 50Ω Load)
RF – Output Power (CW, 50Ω Load)
Output Load VSWR (LTE DL 7.5dB CFR, VCC = 4.5V,
PFORWARD <24dBm)
ESD Rating, All Pins, HBM, JESD22-A114
ESD Rating, All Pins, CDM, JESD22-C101
Moisture Sensitivity Level
Rating
6.0
6.0
6.0
6.0
3.5
+10
+30
8:1
2000
1000
MSL3
Unit
V
V
V
V
V
dBm
dBm
V
V
Caution! ESD sensitive device.
RFMD Green: RoHS status based on EU
Directive 2011/65/EU (at time of this
document revision), halogen free per IEC
61249-2-21, < 1000ppm each of antimony
trioxide in polymeric materials and red
phosphorus as a flame retardant, and
<2% antimony in solder.
Exceeding any one or a combination of the Absolute
Maximum Rating conditions may cause permanent
damage to the device. Extended application of Absolute
Maximum Rating conditions to the device may reduce
device reliability. Specified typical performance or
functional operation of the device under Absolute
Maximum Rating conditions is not implied.
Recommended Operating Condition
Parameter
Operating Temperature Range
Operating Junction Temperature
VBATT
VCC¹
Specification
Min
Typ
Max
-30
+25
+85
125
+3
+3.3
+4.5
+0.5
+3.3
+4.5
Unit
°C
°C
V
V
Note: VCC down to 0.5V may be used for backed-off power when using DC-DC converter to conserve battery current
Nominal Operating Parameters
Parameter
Specification
Unit
Min Typ Max
Condition
General Performance
Operating Frequency
VEN, Low Level
VEN, High Level
VMODE0, VMODE1, Low Level
VMODE0, VMODE1, High Level
Maximum Linear Output POUT^{1, 2}
Thermal Resistance
700
950 MHz
0
0.5
V PA Disabled
1.5 1.8 3
V PA Enabled
0
0.5
V For logic “low”
1.5 1.8 3
V For logic “high”
24
dBm High power mode (HPM); VCC = 3.3V
37
°C/W To backside of evaluation board
Notes:
1.
2.
For operation at VBATT = 3.0V, de-rate POUT by 2.0dB
POUT is specified for 20MHz LTE downlink with CFR 7.5dB, -50dBc ACPR using digital or analog predistortion
RF Micro Devices Inc. 7628 Thorndike Road, Greensboro, NC 27409-9421
For sales or technical support, contact RFMD at +1.336.678.5570 or [e-mail].
DS150209
RF MICRO DEVICES^® and RFMD^® are trademarks of RFMD, LLC. BLUETOOTH is a trademark owned by Bluetooth SIG, Inc., U.S.A. and licensed for use by RFMD. All other trade names,
trademarks, and registered trademarks are the property of their respective owners. ©2013, RF Micro Devices, Inc.
2 of 13