RFLA2018 Datasheet, PDF (2/12 Pages) RF Micro Devices – Variable Gain Low Noise High Linearity Amplifier

RFLA2018
RFMD + TriQuint = Qorvo
Absolute Maximum Ratings
Parameter
Supply Voltage
Control Voltage
DC Supply Current
Power Dissipation
Max RF Input Power
Storage Temperature
ESD Rating (HBM)
ESD Rating (CDM)
Moisture Sensitivity Level
Rating
+5.5
+5.5
400
2000
+22
−40 to +150
1000 (Class 1C)
1000 (Class C3)
MSL3
Units
V
V
mA
mW
dBm
°C
V
V
-
Recommended Operating Conditions
Parameter
Operating Temperature Range
Operating Junction Temperature
Supply Voltage
Specifications
Min
Typ
Max
−40
+85
+160
+4.75
+5.0
+5.25
Caution! ESD sensitive device.
RFMD Green: RoHS status based on EU Directive
2011/65/EU (at time of this document revision), halogen
free per IEC 61249-2-21, < 1000 ppm each of antimony
trioxide in polymeric materials and red phosphorus as a
flame retardant, and <2% antimony in solder.
Exceeding any one or a combination of the Absolute Maximum Rating
conditions may cause permanent damage to the device. Extended
application of Absolute Maximum Rating conditions to the device may
reduce device reliability. Specified typical performance or functional -
operation of the device under Absolute Maximum Rating conditions is
not implied.
Units
° C
° C
V
Electrical Specifications - High Gain Mode, 2500 MHz to 2570 MHz
Parameter
Specification
Min
Typ
Max
Units Conditions
Test conditions unless otherwise noted: Temp. = −40 °C to +85 °C, VCC = +4.75V to +5.25 V,
High Gain Mode, Standard Application Circuit
Operating Frequency Range 2500
2570 MHz
Max Gain
35
39
dB Attenuation = Min, VVA_CV = 0 Volts
Max Gain
36
39
dB Attenuation = Min, VVA_CV = 0 Volts, Temp = +25°C
Gain Flatness
0.2
0.8
dB
Gain Range HG
+14
+35
dB
Output IP3 (Max Gain)
+38
dBm Attenuation = Min, VVA_CV = 0 Volts
Input IP3
−1
+1.5
dBm 19 dB to 35 dB Gain
OP1dB (Max Gain)
+26
dBm Attenuation = Min, VVA_CV = 0 Volts
Input P1dB
−13.5 −10
−12.5
−6
dBm
dBm
33 dB to 35 dB Gain
19 dB to 32 dB Gain
NF (Max Gain)
1.0
1.45
dB Attenuation = Min, VVA_CV = 0 Volts
Input Return Loss ⁽¹⁾
20
23
18
23
25 dB to 35 dB Gain
dB
19 dB to 24 dB Gain
Output Return Loss ⁽¹⁾
15
20
dB 19 dB to 35 dB Gain
S11 Phase Variation
100
Deg
2535 MHz, IRL is between 20 dB and 25 dB over temperature
range +25°C to +85°C
Notes:
1. Minimum Return Loss Specifications can be relaxed 2 dB between −10°C to −40°C
Revision DS20150824
© 2015 RF Micro Devices, Inc.
- 2 of 12 -
Disclaimer: Subject to change without notice
www.rfmd.com / www.qorvo.com