RFFM8209 Datasheet, PDF (2/10 Pages) RF Micro Devices – WiFi Front-End Module 2.4GHz to 2.5GHz

RFFM8209
Absolute Maximum Ratings
Parameter
DC Supply Voltage (No RF Applied)
PA Enable Voltage
DC Supply Current
Operating Ambient Temperature (Ta)
Storage Temperature
Maximum TX Input Power into 50Ω Load (No Damage)
Maximum RX Input Power (No Damage)
Moisture Sensitivity
Nominal Operating Parameters
Parameter
Specification
Min Typ Max
Compliance
Operating Frequency
Operating Temperature
Power Supply VCC
Extended VCC
Control Voltage - High
Control Voltage - Low
Transmit (TX-ANT)
2.412
2.484
-40
85
3.3
3.6
4.2
3
5
2.8
3.1
VCC
0
0.2
11ac Output Power
11ac Dynamic EVM
11n Output Power
11n Dynamic EVM
Spectral Mask
TX Port Return Loss
ANT Port Return Loss
Large Signal Gain
Gain Flatness - 20MHz Channel
Gain Flatness - Across Band
Operating Current
Quiescent Current
PA_EN Current
17.5
15.5
19.5
17.5
20
10
9.6
23.5
22.5
-0.25
-1
18.0
16.0
1.5
-36.5
20
18
2.5
-32.0
22
13
12
26
26
0
0
225
245
265
210
55
1.8
-35.0
3
-30.5
30
31
0.25
1
80
Rating
6
-0.5 to 5
500
-40 to +85
-40 to +150
+12
+12
MSL2
Unit
GHz
ºC
V
V
V
dBm
dBm
%
dB
dBm
%
dB
dBm
dB
dB
dB
dB
dB
dB
mA
mA
mA
mA
µA
Unit
V
VDC
mA
ºC
ºC
dBm
dBm
Caution! ESD sensitive device.
RFMD Green: RoHS status based on EU
Directive 2011/65/EU (at time of this
document revision), halogen free per IEC
61249-2-21, < 1000ppm each of antimony
trioxide in polymeric materials and red
phosphorus as a flame retardant, and
<2% antimony in solder.
Exceeding any one or a combination of the Absolute
Maximum Rating conditions may cause permanent
damage to the device. Extended application of Absolute
Maximum Rating conditions to the device may reduce
device reliability. Specified typical performance or
functional operation of the device under Absolute
Maximum Rating conditions is not implied.
Condition
802.11b, 802.11g, 802.11n, 802.11ac
PA_EN, CRX, CBT, LNA_EN
Temp= 25ºC, VCC = 3.6V, 50% duty cycle unless
otherwise noted
HT20 / HT40
Temp = -10ºC to 70ºC, VCC = 3.3V to 4.2V
At Rated Power; HT20 / HT40; 256QAM
HT20 / HT40
Temp = -10ºC to 70ºC, VCC = 3.3V to 4.2V
At Rated Power; HT20 / HT40; 64QAM
MCS0; HT20 / HT40
T = -10ºC, to +70ºC, VCC = 3.3V to 4.2
POUT = 15.5dBm
POUT = 18dBm
POUT = 20dBm
RF Micro Devices Inc. 7628 Thorndike Road, Greensboro, NC 27409-9421
For sales or technical support, contact RFMD at +1.336.678.5570 or [e-mail].
DS140421
The information in this publication is believed to be accurate. However, no responsibility is assumed by RF Micro Devices, Inc. ("RFMD") for its use, nor for any infringement of patents or other rights of
third parties resulting from its use. No license is granted by implication or otherwise under any patent or patent rights of RFMD. RFMD reserves the right to change component circuitry, recommended
application circuitry and specifications at any time without prior notice.
2 of 10