RFFM6903 Datasheet, PDF (2/11 Pages) RF Micro Devices – 2.5V to 4.2V, ISM Band, 1W 915MHZ Transmit/Receive Module

RFFM6903
RFMD + TriQuint = Qorvo
Absolute Maximum Ratings
Parameter
Voltage
Storage Temperature Range
Operating Temperature Range
Receive RF Input Power (SAW2)
Transmit RF Input Power (PA Enabled)
Transmit RF Input Power (PA Bypass)
Receive RF Input Power (ANT)
T/R Port Load VSWR in Transmit Mode
ESD, HBM
ESD, CDM
Moisture Sensitivity Level
Rating
5.25
-40 to +150
-40 to +85
+5
+15
+20
+33
10:1
350
300
MSL3
Unit
V
°C
°C
dBm
dBm
dBm
dBm
V
V
Caution! ESD sensitive device.
RFMD Green: RoHS status based on EU
Directive 2011/65/EU (at time of this
document revision), halogen free per IEC
61249-2-21, < 1000ppm each of antimony
trioxide in polymeric materials and red
phosphorus as a flame retardant, and
<2% antimony in solder.
Exceeding any one or a combination of the Absolute
Maximum Rating conditions may cause permanent
damage to the device. Extended application of Absolute
Maximum Rating conditions to the device may reduce
device reliability. Specified typical performance or
functional operation of the device under Absolute
Maximum Rating conditions is not implied.
Nominal Operating Parameters
Parameter
Frequency*
RF Port Impedance
Operating Voltage
Leakage Current
VDD
VCC TX
VCC RX
Operating Voltages
VCC TX1/2
VCC RX
VDD
Tx Output Power Control (VAPC)
Specification
Min Typ Max
890 925 960
50
2.5 3.6 4.2
Unit
MHz
Ω
V
0.05 1.0 µA
0.05 1.0 µA
0.05 1.0 µA
Condition
VCCTx1 = 3.6V, VCCTx2 = 3.6V, VDD = 3.6V, VCCRx = 3.6V,
VAPC = 0.0V, EN = 0.0V, TR = 0.0V, BYP = 0.0V, RF = Off,
Temperature = 25ºC
2.5 3.6 4.2
V
2.5 3.3 4.2
V
2.5 3.6 4.2
V
0.00 2.25 2.50 V VAPC operates such that the transmitter output power is saturated at a level
lower than 1.9V and minimal variation in output power of the device occurs
above that level
Revision DS20150709
© 2015 RF Micro Devices, Inc.
2 of 11
Disclaimer: Subject to change without notice
www.rfmd.com / www.qorvo.com