RF5152_11 Datasheet, PDF (2/10 Pages) RF Micro Devices – LINEAR POWER AMPLIFIER

RF5152
Absolute Maximum Ratings
Parameter
Supply Voltage
Power Control Voltage (V_REG)
DC Supply Current
Input RF Power
Operating Ambient Temperature
Storage Temperature
Moisture Sensitivity
Rating
-0.5 to +5.0
-0.5 to +3.5
600
+5
-10 to +85
-40 to +150
JEDEC Level 2
Unit
V
V_DC
mA
dBm
°C
°C
Caution! ESD sensitive device.
Exceeding any one or a combination of the Absolute Maximum Rating conditions may
cause permanent damage to the device. Extended application of Absolute Maximum
Rating conditions to the device may reduce device reliability. Specified typical perfor-
mance or functional operation of the device under Absolute Maximum Rating condi-
tions is not implied.
RoHS status based on EUDirective2002/95/EC (at time of this document revision).
The information in this publication is believed to be accurate and reliable. However, no
responsibility is assumed by RF Micro Devices, Inc. ("RFMD") for its use, nor for any
infringement of patents, or other rights of third parties, resulting from its use. No
license is granted by implication or otherwise under any patent or patent rights of
RFMD. RFMD reserves the right to change component circuitry, recommended appli-
cation circuitry and specifications at any time without prior notice.
Parameter
Specification
Unit
Min.
Typ.
Max.
Condition
Overall
Temperature=+25°C, V_CC=3.3V,
V_REG=2.8V, Frequency=2450MHz,
pulsed at 1% to 100% duty cycle,
circuit per evaluation board schematic
Frequency
2.40
2.50
GHz
IEEE802.11g
IEEE802.11n
Output Power
18
IEEE802.11g modulation, 54Mbit/s, 64QAM,
OFDM modulation
EVM*
2.5
3.3
%
RMS, mean
IP3
33
dBm
Gain
32
34
37
dB
-11dBm Pin
Gain Variance
Input Impedance
1.5
±dB
-15°C to +85°C
49
50
51

Internally Matched Input and Interstage
Output VSWR
10:1
The PA is stable, no spurs above -43dBm
Power Detector (P_detect)
P_OUT = 8 dBm
0.2
0.3
V_DC
P_OUT=18dBm 0.7
0.9
1.1
V_DC
Power Supply
Operating Voltage
3.0
3.3
3.6
V
V_REG (Bias) Voltage (VB1/VB2,
2.7
2.8
3.0
V_DC
VB3)
Current Consumption
85
130
170
mA
RF P_OUT=+18dBm, V_CC=3.3V,
54Mbps OFDM <2.5% EVM
Quiescent Current
V_REG (Bias) Current (Total)
Input Return Loss
45
75
105
mA
V_CC=+3.3V_DC; RF In=OFF; V_REG OFF
1
2
6
mA
V_CC = 3.3 V
-15
-10
dB
Turn-on Time**
300
700
1000
nS
Output stable to within 90% of final gain
Notes:
*The EVM specification is obtained with a signal generator that has an EVM floor of less than 0.7%.
**The PA must operate with gated bias voltage input at 1% to 99% duty cycles without any EVM or other parameter degradation.
2 of 10
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
DS110617