SF2255E Datasheet, PDF (1/4 Pages) RF Monolithics, Inc – 1056 MHz SAW Filter

• Low-loss RF SAW Filter
• Miniature 3 x 3 mm SMD Package
• Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-grounded Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Maximum Soldering Profile, 5 cycles/10 seconds maximum
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss, 1041 to 1071 MHz
Amplitude Ripple, 1041 to 1071 MHz
VSWR, 1041 to 1071 MHz
Attenuation, Referenced to 0 dB:
1006 MHz
1106 MHz
1146 MHz
Source Impedance
Load Impedance
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 inch
Reel Size 13 inch
Electrical Connections
Connection
Input
Terminals
2
Output
5
Case Ground
All others
SF2255E
Value
+10
3
-30 to +85
-40 to +85
265
Units
dBm
V
°C
°C
°C
1056 MHz
SAW Filter
SM3030-6
Sym Notes
Min
f_C
IL
Typ
1056
2.6
0.8
1.9:1
Max
3.5
1.5
2.2:1
40
42
25
34
40
46
Z_S
50
Z_L
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
A02, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Units
MHz
dB
dB_P-P
dB
Ω
Ω
50 ohm
2
5
S A W F ilte r
1,3,4,6
50 ohm
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. The design, manufacturing process, and specifications of this filter are subject to change.
5. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
6. US and international patents may apply.
7. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: [e-mail]
©2010 by RF Monolithics, Inc.
Page 1 of 4
SF2255E - 11/18/10