SF2205E Datasheet, PDF (1/5 Pages) RF Monolithics, Inc – 879 MHz SAW Filter

Preliminary
• Surface-mount 3.0 x 3.0 x 1.3 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Solder Reflow Temperature, 10 seconds, 5 cycles maximum
Pb
Value
10
3
-25 to +75
-40 to +85
260
Units
dBm
V
°C
°C
°C
SF2205E
879 MHz
SAW Filter
Electrical Characteristics
Characteristic
Center Frequency
Maximum Insertion Loss, 864 to 894 MHz
Amplitude Ripple, 864 to 894 MHz
I/O Return Loss, 864 to 894 MHz
Attenuation Referenced to 0 dB:
10 to 840 MHz
920 to 1000 MHz
1000 to 2600 MHz
Source Impedance
Load Impedance
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
Electrical Connections
Connection
Input
Output
Ground
Terminals
5
2
All Others
SM3030-6
Sym Notes
Min
Typ
Max
F_C
879
IL
3.5
2.0
10
40
30
25
Z_S
50
Z_L
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
937, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Units
MHz
dB
dB_P-P
dB
dB
Ω
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
www.RFM.com E-mail: [e-mail]
©2009-2010 by RF Monolithics, Inc.
Page 1 of 5
SF2205E - 7/16/10